Prusa3D Forum

Notifications

Clear all

david.w8

Group: Registered

Joined: 2016/11/12

Eminent Member

	MK2 to MK2.5 (not MK2.5S) upgrade instructions In forum Assembly and first prints troubleshooting	2 years ago
	did you use filament cooling (fan) during printing? I faced ... In forum Others (Archive)	6 years ago
	ie. The printers do not appear to be in an enclosure but the... In forum Others (Archive)	6 years ago
	Some more data to share here... I had a ~6 hour print run t... In forum Improvements (Archive)	6 years ago
	I have an actively heated enclosure, although I've found the... In forum Improvements (Archive)	6 years ago
	The 12V supply going into the Mini Rambo 1.3a (what came in ... In forum Improvements (Archive)	6 years ago
	Bump... In forum Others (Archive)	6 years ago
	another point to mention: the genuine psu of the i3 mk2 acts... In forum Improvements (Archive)	6 years ago
	Late reply here, but I've found that warming the bed up just... In forum Print tips (Archive)	6 years ago
	Could you post here what you replaced them with for posterit... In forum Others (Archive)	6 years ago
	Why are vent holes removed on MK2S rambo base?? In forum Others (Archive)	7 years ago
	Printing a solid raft of PETG under Nylon In forum Print tips (Archive)	7 years ago
	You might try one of the high temperature PLAs like Raptor P... In forum Others (Archive)	7 years ago
	All the prints worked fine for me even using a non-prusa PLA... In forum Others (Archive)	7 years ago
	I had the same issue, turned out to be that the XY frame had... In forum Others (Archive)	7 years ago
	I went to 1000 and it got rid of a lot of noise and shaking,... In forum Print tips (Archive)	7 years ago
	I've measured power at the wall, and even printing ABS at al... In forum Improvements (Archive)	7 years ago
	My problem is that both the reader and LCD are flaky. I've j... In forum Prusa i3 kit (Archive)	7 years ago
	but the case is intended to keep the heat inside and heat is... In forum Others (Archive)	7 years ago
	I built an enclosure around mine using a sheet of 1/2" rigid... In forum Others (Archive)	7 years ago

Page 1 / 2 Next

Forum Statistics

535 Forums

59.4 K Topics

426.3 K Posts

15 Online

63.8 K Members

Latest Post: Print head getting dropped in middle of print Our newest member: Charles Jacques Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed