david.m17
david.m17
Group: Registered
Joined: 2016/11/25
Active Member
1
These pictures and this code were a Godsend! Thank you very...

In forum Assembly and first prints troubleshooting

3 years ago
The end of the story -- As it turns out, the PINDA was fine...

In forum Assembly and first prints troubleshooting

3 years ago
Suggestions on how to proceed?

In forum Assembly and first prints troubleshooting

4 years ago
Interesting. I can get the PINDA probe to flash by putting ...

In forum Assembly and first prints troubleshooting

4 years ago
Thanks for that idea, but that is not something I have layin...

In forum Assembly and first prints troubleshooting

4 years ago
Ferrous metal attached to the bed did nothing to change the ...

In forum Assembly and first prints troubleshooting

4 years ago
"this should allow a correct detection of the printbed inlay...

In forum Assembly and first prints troubleshooting

4 years ago
Anyone with additional ideas?

In forum Assembly and first prints troubleshooting

4 years ago
The base of mine is illuminated where it connects to the cab...

In forum Assembly and first prints troubleshooting

4 years ago
I understand that, however, the PINDA cannot go any lower wi...

In forum Assembly and first prints troubleshooting

4 years ago
Thank you. I have verified that the Y axis is completely do...

In forum Assembly and first prints troubleshooting

4 years ago
I forgot to mention - yes the bed is heated.

In forum Assembly and first prints troubleshooting

4 years ago
Print nozzle hitting bed with PINDA all the way down.

In forum Assembly and first prints troubleshooting

4 years ago
Share:

Please Login or Register