Notifications
Clear all
david.b14
david.b14
Group: Registered
Joined: 2016/10/31
Honorable Member
1
Nice example of controlling RGB w/ I2C: Simple bridge betw...

In forum Others (Archive)

7 years ago
Cool, thanks for the info. So are those the pin headers loc...

In forum Others (Archive)

7 years ago
MK2 Rambo pin available for LED control w/ Gcode?

In forum Others (Archive)

7 years ago
It would be cool if an option was available to print in quie...

In forum Hardware, firmware and software help

7 years ago
Maybe the following will help: - Slowing down the print. - A...

In forum Others (Archive)

7 years ago
I loaded a gcode file, but the model would not render using ...

In forum Hardware, firmware and software help

7 years ago
I like how the is a icon that will let me rotate things with...

In forum Hardware, firmware and software help

7 years ago
I really like the interface which is handy when you have to ...

In forum Hardware, firmware and software help

7 years ago
Cura also supports this Nice write up for Slic3r:

In forum Others (Archive)

7 years ago
Surprisingly good heat properties of Prusa Black PLA.

In forum Print tips (Archive)

7 years ago
In order to get another data point, have you considered usin...

In forum Others (Archive)

7 years ago
By nubs, do you mean like the supports Meshmixer creates?

In forum Print tips (Archive)

7 years ago
Looks like you did not enable support in the slicer options,...

In forum Prusa i3 kit (Archive)

7 years ago
PE Slic3r: Support settings, why is the default at 43?

In forum Print tips (Archive)

7 years ago
Good point. I was concerned that the drill bit may break of...

In forum Prusa i3 kit (Archive)

7 years ago
PE slic3r settings to get best results for this part using ....

In forum Print tips (Archive)

7 years ago
I think it may be a cost / complexity / time tested design i...

In forum Improvements (Archive)

7 years ago
Y-Frame holes for upgrading MK2 to MK2S

In forum Prusa i3 kit (Archive)

7 years ago
Most awesome PLA nickel finish tutorial

In forum Print tips (Archive)

7 years ago
Also, did you following the recommended print speeds?

In forum Print tips (Archive)

7 years ago
Page 2 / 30
Share: