david.a66
david.a66
Group: Registered
Joined: 2019/02/14
Honorable Member
1
the lights and button functions are all documented in the MM...

In forum Assembly and first prints troubleshooting

3 months ago
@pjr the MK3(s) uses Linear Advance 1.0 with nominal values ...

In forum Hardware, firmware and software help

3 months ago
that's the seam line. an inherent part of 3d printing

In forum How do I print this? (Printing help)

3 months ago
100K for Prusa thermisters at room temp

In forum Assembly and first prints troubleshooting

3 months ago
@shadow703793 jo prusa announced in an interview after ERRF ...

In forum General discussion, announcements and releases

3 months ago
your print bed has finger prints/oil on it . time to give is...

In forum How do I print this? (Printing help)

3 months ago
turning the heater block will not allow the part cooling duc...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
the external SPI flash is used for multi language support - ...

In forum General discussion, announcements and releases

3 months ago
your PINDA height has changed - redo the Pinda mechanical he...

In forum Hardware, firmware and software help

3 months ago
possible causes: enclosure ?ambient room tempretractions on ...

In forum General discussion, announcements and releases

3 months ago
mini uses the buddy board and all new 32 bit firmware

In forum General discussion, announcements and releases

3 months ago
check the y axis for smooth movement with the power off and ...

In forum Hardware, firmware and software help

3 months ago
the mmu only homes when the first commands are sent to it, n...

In forum Hardware, firmware and software help

3 months ago
without the volumetric limit you are trying to print infill ...

In forum Hardware, firmware and software help

3 months ago
have you actually lowered the max volumetric limit and not j...

In forum Hardware, firmware and software help

3 months ago
octoprint works with the mini, just use the mini-usb port on...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
it's intentional - to pump the remaining hot plastic out bef...

In forum General discussion, announcements and releases

3 months ago
same nozzles for mini and mk3

In forum General discussion, announcements and releases

4 months ago
if you can't move the extruder on the x axis with the power ...

In forum Hardware, firmware and software help

4 months ago
check the "crash" counters - if you are getting crashes your...

In forum Assembly and first prints troubleshooting

4 months ago
Page 1 / 33
Share:

Please Login or Register