Notifications
Clear all
DarcShadow
DarcShadow
Group: Registered
Joined: 2019/05/29
Trusted Member
3
SpeakerSpacer_Viper v5

In forum PrusaSlicer

8 months ago
First layer Width not coming out correct

In forum PrusaSlicer

8 months ago
@neophyl Sorry, some how missed that post, and it even had a...

In forum PrusaSlicer

3 years ago
Have you considered rotating the part? If you lay it down so...

In forum PrusaSlicer

3 years ago
More time consuming than printing in different colors? For t...

In forum How do I print this? (Printing help)

3 years ago
Just an fyi, if you ever need to add an outline to an image ...

In forum How do I print this? (Printing help)

4 years ago
That's pretty cool. There's no settings in the slicer to get...

In forum How do I print this? (Printing help)

4 years ago
I would suspect an over heating issue. PETG needs to be extr...

In forum Hardware, firmware and software help

4 years ago
Adjust your Live Z setting

In forum Hardware, firmware and software help

4 years ago
Something else to look at is number of perimeters. You can t...

In forum Hardware, firmware and software help

4 years ago
Never used it on a printer sheet. Just saying Acetone will s...

In forum General discussion, announcements and releases

4 years ago
Is there room on the build plate for a brim or mouse ears on...

In forum How do I print this? (Printing help)

4 years ago
I had a problem similar where in addition to "seeing" the in...

In forum How do I print this? (Printing help)

4 years ago
From his photo it's a void in the printed object, technicall...

In forum How do I print this? (Printing help)

4 years ago
I do powder coating occasionally and acetone is one of the f...

In forum General discussion, announcements and releases

4 years ago
The surface being supported will never be as smooth as if pr...

In forum How do I print this? (Printing help)

4 years ago
There are a couple of ways to do it. You could manually edit...

In forum How do I print this? (Printing help)

4 years ago
When printing with supports, the first layer that prints on ...

In forum How do I print this? (Printing help)

4 years ago
Have you tried adding a brim?

In forum Assembly and first prints troubleshooting

4 years ago
I suspect it may be your model is at fault. Some times when ...

In forum PrusaSlicer

4 years ago
Page 1 / 4
Share: