darcshadow
darcshadow
Group: Registered
Joined: 2019/05/29
Eminent Member
2
How are you inserting the filament exactly? Have you cut the...

In forum Assembly and first prints troubleshooting

7 hours ago
Rather than a simple switch you could use a keyed switch, li...

In forum Hardware, firmware and software help

3 weeks ago
I had a problem similar to this and it turned out to be a fl...

In forum General discussion, announcements and releases

2 months ago
What version of the slicer are you using? I have not had any...

In forum PrusaSlicer

2 months ago
Defining life of the printer is kind of hard as well because...

In forum General discussion, announcements and releases

2 months ago
Agree, little like buying a Ferrari then parking it under a ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
By the time you buy all the tables and made the various modi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Print Settings -> Advanced -> Extrusion Width Infill

In forum General software discussion

3 months ago
While the "correct" way would be to build the file to load t...

In forum How do I print this? (Printing help)

3 months ago
Ah, thanks for the info. That triangle appears on so many st...

In forum PrusaSlicer

3 months ago
Unexpected bridging at 0.15mm layer height No bridging at 0...

In forum PrusaSlicer

3 months ago
Update: Just noticed that the bridge only appears when layer...

In forum PrusaSlicer

3 months ago
Unexpected Bridging

In forum PrusaSlicer

3 months ago
Are you using the solid model or the hollow one? Vase mode o...

In forum How do I print this? (Printing help)

6 months ago
Updated the firmware and the mesh bed level settings are the...

In forum Hardware, firmware and software help

10 months ago
If it is oozing during the mesh bed leveling wouldn't that i...

In forum Hardware, firmware and software help

10 months ago
Bed Level Correction and Calibrate XYZ

In forum Hardware, firmware and software help

10 months ago
I figured that would fix it, but I shouldn't have to, it was...

In forum Hardware, firmware and software help

10 months ago
I'll have to go back and look at the FW version, but it's pr...

In forum Hardware, firmware and software help

10 months ago
There is a think in the calibration menu, but it just runs t...

In forum Hardware, firmware and software help

10 months ago
Page 1 / 3
Share:

Please Login or Register