curtis.c2
curtis.c2
Group: Registered
Joined: 2017/10/12
Honorable Member
1
the lifting is definitely causing that....should not need a ...

In forum How do I print this? (Printing help)

2 years ago
thats actually pretty decent for supported layers. if more...

In forum How do I print this? (Printing help)

2 years ago
Do not do this, scotchbrite/scouring pad/000 steel wool. I...

In forum Assembly and first prints troubleshooting

2 years ago
might want to contact support, the displays have a high fail...

In forum Assembly and first prints troubleshooting

2 years ago
I know Pause and Stop are in OctoPrint, but it does not move...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
make sure clean the nozzle before it starts the mesh, that i...

In forum Hardware, firmware and software help

2 years ago
scotchbrite/scouring pad/000 steel wool, scuff up the bed an...

In forum Assembly and first prints troubleshooting

2 years ago
don't focus on the dimensions, worry about the quality first...

In forum Assembly and first prints troubleshooting

2 years ago
So I wonder if is it possible to write a G code especially f...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Is there something I can do to improve this? are you lett...

In forum How do I print this? (Printing help)

2 years ago
printing from sdcard? try using stealth mode or turning off ...

In forum Hardware, firmware and software help

2 years ago
Hi , I´m printing with NylonX (Nylon + Carbon fiber), and i ...

In forum How do I print this? (Printing help)

2 years ago
try not to overthink it, just scuff it up with scotchbrite o...

In forum How do I print this? (Printing help)

2 years ago
high grit sandpaper and/or scotchbrite and/or steel wool scr...

In forum How do I print this? (Printing help)

2 years ago
its worth noting that the values it gives you are not intend...

In forum Assembly and first prints troubleshooting

2 years ago
its possible the z nuts are binding. loosen them up a turn ...

In forum Hardware, firmware and software help

2 years ago
It's then saying calibration failed.. so I'm just trying to ...

In forum Hardware, firmware and software help

2 years ago
there are several out there, this one works not a big fan ...

In forum Hardware, firmware and software help

2 years ago
What are the desired engineered heights? 1. Is it the PINDA ...

In forum Hardware, firmware and software help

2 years ago
Thanks , that helps. So are we saying that the Belt status v...

In forum Hardware, firmware and software help

2 years ago
Page 1 / 29
Share:

Please Login or Register