Notifications
Clear all
Crawlerin
Crawlerin
Group: Registered
Joined: 2019/09/20
Prominent Member
2
This one is also good 🙂

In forum Input Shaper (MINI)

3 months ago
Hello, Your first layer looks OK, but forget 70% alcohol. Wa...

In forum Assembly and first prints troubleshooting

2 years ago
Rumors have it it has something to do with light (either nat...

In forum General discussion, announcements and releases

2 years ago
I'd increase infill density, increase cooling on bridging (b...

In forum Hardware, firmware and software help

2 years ago
It could have happened. At which point does the calibration ...

In forum Hardware, firmware and software help

2 years ago
Sorry haven't seen this post. Check belt tension - it needs ...

In forum Hardware, firmware and software help

2 years ago
To me it looks like there may be some issue in Z movement, w...

In forum Hardware, firmware and software help

2 years ago
I am glad you have your printer in order now 🙂 Those ar...

In forum Hardware, firmware and software help

2 years ago
There is a mod, similar to that of Nylock mod on MK3, to mak...

In forum Hardware, firmware and software help

2 years ago
There is short PTFE tube inside extruder as well. Inte...

In forum Hardware, firmware and software help

2 years ago
It's a thing which moves and untangles 😀 That's enough I t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
That's a really nice filament 😮 Release the tensioner, I had...

In forum Hardware, firmware and software help

2 years ago
I know my ball I mean steel ball in filament sensor is rattl...

In forum Hardware, firmware and software help

2 years ago
By any chance, did you upgrade to 3.4.4, and do you have you...

In forum Hardware, firmware and software help

2 years ago
MINI can reach temperatures sufficient to print ASA and ABS,...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Ahh, these pop up from time to time when somebody "discovers...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Ha, I was thinking that with rise of smaller pancake stepper...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
You said you tried everything on tension, have you tried rea...

In forum Hardware, firmware and software help

3 years ago
Yeah there may be a difference then, in order to buy from th...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Very nice! Misumi has extrusions, but they don't accept end ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Page 1 / 42
Share: