|
Thanks for the reply. "One does not simply walk into Mordor!... In forum General discussion, announcements and releases |
4 months ago |
|
Z-Axis rise on filament change In forum General discussion, announcements and releases |
4 months ago |
|
@lichtjaeger Hi. I refuse to by pricey "special" resin clean... In forum General discussion, announcements and releases |
4 years ago |
|
Hi. I'm based in germany, so the Mean Green is not available... In forum General discussion, announcements and releases |
4 years ago |
|
Cloudy FEP In forum General discussion, announcements and releases |
4 years ago |
|
Thanks for the revelation and sorry for being german 😆 ... In forum Hardware, firmware and software help |
5 years ago |
|
Slic3r PE settings issues In forum Hardware, firmware and software help |
5 years ago |
|
Wohaa, that's some home shop! I know only one man with a Bri... In forum Hardware, firmware and software help |
5 years ago |
|
My two cents: I have spliced in a more flexible and slightly... In forum Hardware, firmware and software help |
5 years ago |
|
That temp jump is the start of the print. Had to re-slice be... In forum Hardware, firmware and software help |
5 years ago |
|
Morning (yawns)
Tested according to the procedure you propo... In forum Hardware, firmware and software help |
5 years ago |
|
Thanks for the hint. I'll ttry that.
Don't know if it explai... In forum Hardware, firmware and software help |
5 years ago |
|
Failing hotend thermistor? In forum Hardware, firmware and software help |
5 years ago |
|
Hi.
Thanks for the research and sharing your experiences.
... In forum Hardware, firmware and software help |
5 years ago |
