|
I think the autoload procedure only refers to the sensor det... In forum Hardware, firmware and software help |
4 years ago |
|
Catbus In forum Awesome prints (Hall Of Fame) |
4 years ago |
|
I'm a vegan, so no Haribo for me anyway 🤣 But thanks for the... In forum Hardware, firmware and software help |
4 years ago |
|
@frank-the-rock Thanks for the illustration, I think I get i... In forum Hardware, firmware and software help |
4 years ago |
|
and you really need to align them perfectly square before tr... In forum Hardware, firmware and software help |
4 years ago |
|
The distances between the rods on my assemled printer are:le... In forum Hardware, firmware and software help |
5 years ago |
|
@vojtech:Thanks for all the suggestions ans explanations! Th... In forum Hardware, firmware and software help |
5 years ago |
|
So after about five months of use I can add scratched rods t... In forum Hardware, firmware and software help |
5 years ago |
|
Usually when using bullet terminals like those on a project,... In forum User mods - OctoPrint, enclosures, nozzles, ... |
5 years ago |
|
jonnieZG wrote: ↑
11 Dec 2018, 21:41
Let me just cut... In forum User mods - OctoPrint, enclosures, nozzles, ... |
5 years ago |
|
do you mean you had the same issue before you even installed... In forum Hardware, firmware and software help |
5 years ago |
|
To me the strangest part of this is the bed levelling is sup... In forum Hardware, firmware and software help |
5 years ago |
|
after i posted this i found that the only way to zoom in is ... In forum Hardware, firmware and software help |
5 years ago |
|
the best prep for your bed is to wash it with warm water and... In forum Hardware, firmware and software help |
5 years ago |
|
I got my Mk3 in November too, also with a powder-coated shee... In forum Hardware, firmware and software help |
5 years ago |
|
Concerning the belt tension I'd like to repeat what I wrote ... In forum Hardware, firmware and software help |
5 years ago |
|
Just wanted to add something I know / found out about fans. ... In forum Hardware, firmware and software help |
5 years ago |
|
Are you printing in an enclosure or an environment that's wa... In forum Hardware, firmware and software help |
5 years ago |
|
The belt status values seem to be more of a guide than an ex... In forum Hardware, firmware and software help |
5 years ago |
|
I confirm it was the sheet thickness and an air bubble.
In... In forum Hardware, firmware and software help |
5 years ago |
