chris.p8
chris.p8
Group: Registered
Joined: 2017/02/08
Trusted Member
3
Interesting! Over the weekend I refitted the silicon 'sock' ...

In forum Hardware, firmware and software help

1 year ago
Tried turning the fan off but it still ran after a while?? I...

In forum Hardware, firmware and software help

1 year ago
Thermal runaway...

In forum Hardware, firmware and software help

1 year ago
How about using a modifier? If you check the blog there is a...

In forum How do I print this? (Printing help)

1 year ago
If you get stuck , I could print them for you - I am in the ...

In forum Assembly and first prints troubleshooting

1 year ago
Bit late (I have been on leave) but if Joan has not sorted y...

In forum General discussion, announcements and releases

1 year ago
Thanks - I don't get this during printing, only on the initi...

In forum Hardware, firmware and software help

1 year ago
Firmware bugs?

In forum Hardware, firmware and software help

1 year ago
Ok, thanks very much - better to focus on one tool, although...

In forum General discussion, announcements and releases

2 years ago
After struggling with this for a while I contacted Prusa 'ch...

In forum How do I print this? (Printing help)

2 years ago
I found that that the latest (6.1?) example causes a proble...

In forum Assembly and first prints troubleshooting

2 years ago
The PrusaControl software still shows as 0.9.4_415_beta and ...

In forum General discussion, announcements and releases

2 years ago
Thank you Tim - I am pretty sure my nozzle does not show muc...

In forum How do I print this? (Printing help)

2 years ago
Wish I'd never installed it now! Just can't get the calibra...

In forum How do I print this? (Printing help)

2 years ago
New V3 extruder

In forum How do I print this? (Printing help)

2 years ago
I have had this problem when building things and it was the ...

In forum Hardware, firmware and software help

2 years ago
New extruder parts for 2.5

In forum Hardware, firmware and software help

2 years ago
Gaps between slices?

In forum How do I print this? (Printing help)

2 years ago
Thanks very much - so my logic was good, never really occurs...

In forum How do I print this? (Printing help)

2 years ago
Printing layer heights

In forum How do I print this? (Printing help)

2 years ago
Page 1 / 5
Share:

Please Login or Register