chris.n6
chris.n6
Group: Registered
Joined: 2017/09/25
Reputable Member
5
also for autoload i think you have to have the filament sens...

In forum General discussion, announcements and releases

5 months ago
@bruce-b5 it was that way in 3.7 also i thought. 210 isn't w...

In forum General discussion, announcements and releases

5 months ago
It could be a loose screw, belt, or bearing, or it could be ...

In forum Hardware, firmware and software help

6 months ago
Yeah, that or if there is too much difference between the re...

In forum Hardware, firmware and software help

6 months ago
how does it fail? is there something specific that fails?

In forum Hardware, firmware and software help

6 months ago
just thought of one other possibility. is the print fan shro...

In forum How do I print this? (Printing help)

7 months ago
no doubt that is true. But i'm thinking it is the sensor its...

In forum How do I print this? (Printing help)

7 months ago
So, have you tried printing on the second side? If you still...

In forum How do I print this? (Printing help)

7 months ago
thanks for the suggestion but i have parts on the way and I ...

In forum How do I print this? (Printing help)

7 months ago
Not sure what you are telling me. I have reprinted the fs le...

In forum How do I print this? (Printing help)

7 months ago
it is Chris, not david, and I did it by layerheight. The fia...

In forum How do I print this? (Printing help)

7 months ago
Thank you Joan! I ended up getting a reply on r/prusa in abo...

In forum How do I print this? (Printing help)

7 months ago
combining objects - HELP

In forum How do I print this? (Printing help)

7 months ago
I disagree a bit with this rating. Given that you are testin...

In forum General discussion, announcements and releases

9 months ago
The prices were always too low. The reason they are unobtai...

In forum General discussion, announcements and releases

9 months ago
The support employee supposed, I might have damaged it durin...

In forum Hardware, firmware and software help

12 months ago
To me the strangest part of this is the bed levelling is sup...

In forum Hardware, firmware and software help

12 months ago
If it ain't broke don't fix it.... In your case I'd say it ...

In forum Hardware, firmware and software help

12 months ago
....So I would be interested to see the diff in them, if any...

In forum Hardware, firmware and software help

12 months ago
As an aside, I've not checked the V3 sheet using 7x7 mesh be...

In forum Hardware, firmware and software help

12 months ago
Page 1 / 18
Share:

Please Login or Register