|
I use SUNLU PETG at a print temperature of 215 Dec, First la... Dans le forum General discussion, announcements and releases |
il y a 3 years |
|
Even though I know FDM printing has limitations, rather than... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Thanks for the info Bobstro, this will be a useful feature. Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Also take into consideration extrusion widths. With a 0.4mm ... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
I find that printing with PETG when using 3mm screws, I don'... Dans le forum How do I print this? (Printing help) |
il y a 4 years |
|
Depends on how many filaments you want to dry at once and yo... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
I assume that you have already let the fan run at full speed... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
If their suppliers can get the parts to them that is. Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Oil is great until that time you have a long print (>24 h... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Looks very similar 😀 I've been using one of these dehidrato... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Already exported all my drawings to local disk. Just install... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Biggest difference to noise reduction I found is as Bobstro ... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
I use a lab glass block like this:/p> (But got it much cheap... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Here you go, 30 seconds. Seems to work just fine, but I g... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
I use 2 x 500g tor 1 x 1000g desiccant bags designed for use... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Finally the dryer in Tim's post (The stainless steel one) is... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
I also think I might try the glue stick on the Buildtak surf... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Thanks for the quick reply Charles, so you think I might exp... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Finally ordered some Prusament PC blend and it should be wit... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
I used the following - before the magnets fell out, but will... Dans le forum Hardware, firmware and software help |
il y a 4 years |
