|
I use SUNLU PETG at a print temperature of 215 Dec, First la... In forum General discussion, announcements and releases |
3 years ago |
|
Even though I know FDM printing has limitations, rather than... In forum Hardware, firmware and software help |
4 years ago |
|
Thanks for the info Bobstro, this will be a useful feature. In forum Hardware, firmware and software help |
4 years ago |
|
Also take into consideration extrusion widths. With a 0.4mm ... In forum Hardware, firmware and software help |
4 years ago |
|
I find that printing with PETG when using 3mm screws, I don'... In forum How do I print this? (Printing help) |
4 years ago |
|
Depends on how many filaments you want to dry at once and yo... In forum General discussion, announcements and releases |
4 years ago |
|
I assume that you have already let the fan run at full speed... In forum Hardware, firmware and software help |
4 years ago |
|
If their suppliers can get the parts to them that is. In forum General discussion, announcements and releases |
4 years ago |
|
Oil is great until that time you have a long print (>24 h... In forum General discussion, announcements and releases |
4 years ago |
|
Looks very similar 😀 I've been using one of these dehidrato... In forum General discussion, announcements and releases |
4 years ago |
|
Already exported all my drawings to local disk. Just install... In forum General discussion, announcements and releases |
4 years ago |
|
Biggest difference to noise reduction I found is as Bobstro ... In forum Hardware, firmware and software help |
4 years ago |
|
I use a lab glass block like this:/p> (But got it much cheap... In forum General discussion, announcements and releases |
4 years ago |
|
Here you go, 30 seconds. Seems to work just fine, but I g... In forum General discussion, announcements and releases |
4 years ago |
|
I use 2 x 500g tor 1 x 1000g desiccant bags designed for use... In forum General discussion, announcements and releases |
4 years ago |
|
Finally the dryer in Tim's post (The stainless steel one) is... In forum General discussion, announcements and releases |
4 years ago |
|
I also think I might try the glue stick on the Buildtak surf... In forum General discussion, announcements and releases |
4 years ago |
|
Thanks for the quick reply Charles, so you think I might exp... In forum General discussion, announcements and releases |
4 years ago |
|
Finally ordered some Prusament PC blend and it should be wit... In forum General discussion, announcements and releases |
4 years ago |
|
I used the following - before the magnets fell out, but will... In forum Hardware, firmware and software help |
4 years ago |
