Activity
 
Notifications
Clear all
Chocki
Chocki
Group: Registered
Joined: 2018/09/27
Prominent Member
2
If your running higher currents then you should fit heatsink...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I found printing PETG with the lowest fan speed you can and ...

In forum General discussion, announcements and releases

2 years ago
Thanks for this, saves me some work. Just for anyone else, p...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Printing through USB is not recommended as it is prone to st...

In forum Hardware, firmware and software help

2 years ago
Has anyone tried airbrushing with UV resin, then zapping wit...

In forum General discussion, announcements and releases

2 years ago
Pre-order pricing and exchange rates next year?

In forum General discussion, announcements and releases

2 years ago
Will there be any issues with ordering from the UK?, I don't...

In forum General discussion, announcements and releases

2 years ago
I'll try putting it in the dehydrator for a few hours and se...

In forum General discussion, announcements and releases

3 years ago
It's Prusa PC blend in black, and it is not sticking to this...

In forum General discussion, announcements and releases

3 years ago
So some time later.... PC doesn't stick well enough to this ...

In forum General discussion, announcements and releases

3 years ago
Bad news, these cards have been discontinued, any remaining ...

In forum Hardware, firmware and software help

3 years ago
Carry out a factory reset of the printer when you upgrade fi...

In forum Hardware, firmware and software help

3 years ago
Just be aware you will show ringing up more and possibly red...

In forum General discussion, announcements and releases

3 years ago
JohnDess beat me to it. Have you tried printing the external...

In forum General discussion, announcements and releases

3 years ago
I have used this filament before, and found it good, but be ...

In forum General discussion, announcements and releases

3 years ago
So, after trying and destroying various build surfaces, I ca...

In forum General discussion, announcements and releases

3 years ago
Polycarbonate printing on FYSETC textured sheet review

In forum General discussion, announcements and releases

3 years ago
The got2b hair spray direct on steel does not grip polycarbo...

In forum How do I print this? (Printing help)

3 years ago
Thanks Charles, I'd just add my pennies worth. I found PETG ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Bed adhesion with polycarbonate question

In forum How do I print this? (Printing help)

3 years ago
Page 1 / 49
Share: