charles.h13
charles.h13
Group: Registered
Joined: 2018/07/13
Famed Member
@jurassic73 Are you sure you updated to 3.91 - that is the R...

In forum Hardware, firmware and software help

38 mins ago
@jurassic73 No, hold the selector down while power on. That...

In forum Hardware, firmware and software help

40 mins ago
@jurassic73 I did a hard reset and that sometimes fixes it. ...

In forum Hardware, firmware and software help

1 hour ago
Sure fire ways to cause a jam!

In forum General discussion, announcements and releases

2 hours ago
This is a problem between the Prusa and Octoprint. It is fi...

In forum Hardware, firmware and software help

3 hours ago
In general, you are correct. This is true for a new sheet. ...

In forum How do I print this? (Printing help)

4 hours ago
@michael-cwienczek There are similar products in Europe: D...

In forum How do I print this? (Printing help)

5 hours ago
I general, you might be right. It is very subtle.

In forum General discussion, announcements and releases

9 hours ago
@michael-cwienczek I have to second the Layerneer Bed Weld o...

In forum How do I print this? (Printing help)

9 hours ago
@bobstro I personally find the differences very subtle. I n...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 day ago
@wolfiebot You will soon. Do not be concerned about orders ...

In forum General discussion, announcements and releases

1 day ago
200 pages and counting!

In forum General discussion, announcements and releases

1 day ago
100% agree

In forum General discussion, announcements and releases

1 day ago
I installed a 32 bit Big Tree Tech board one my Ender. The ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 day ago
I keep a couple extra thermistors and a hotend around just i...

In forum Hardware, firmware and software help

2 days ago
I just bought a photo booth on Amazon to help me take better...

In forum General discussion, announcements and releases

2 days ago
@vintagepc Adobe has a similar exodus. I think you are prob...

In forum General discussion, announcements and releases

2 days ago
I don’t get the change.

In forum General discussion, announcements and releases

2 days ago
Hello, I have also had the problem. I have found it cause...

In forum Assembly and first prints troubleshooting

2 days ago
I would recommend a good pair of Chanel Locks or a wrench to...

In forum General discussion, announcements and releases

4 days ago
Page 1 / 167
Share:

Please Login or Register