charles.h13
charles.h13
Group: Registered
Joined: 2018/07/13
Famed Member
@cmbanash Yes. To reduce warping: Check your Z height - som...

In forum General discussion, announcements and releases

3 hours ago
@cmbanash I used the standard Prusament PLA. No warping wha...

In forum General discussion, announcements and releases

4 hours ago
Sure: I used a glue stick and. .6-1.0 nozzle with 0.4mm laye...

In forum How do I print this? (Printing help)

4 hours ago
I understand the anger also. I am not casting blame, but I ...

In forum General discussion, announcements and releases

11 hours ago
@antoninus Instead of arguing with the mod: This is probably...

In forum PrusaSlicer

13 hours ago
This is probably a better place:/p>

In forum PrusaSlicer

13 hours ago
That is rippling or waving and it is caused by the first lay...

In forum Assembly and first prints troubleshooting

1 day ago
@markus-grunwald Check your z and clean your plate. Those a...

In forum General discussion, announcements and releases

1 day ago
@jsw I do not use it for cold pulls. I use it differently.

In forum General discussion, announcements and releases

1 day ago
@rtibbetts Just post the list of parts and files you used to...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 day ago
I will try adding some thermal paste and see if it lowers th...

In forum Hardware, firmware and software help

1 day ago
No so sure I would agree. There are varying experiences. I...

In forum General discussion, announcements and releases

1 day ago
@dan-p12 I sell a few on eBay. They sell pretty well.

In forum How do I print this? (Printing help)

1 day ago
@jsw I have found that using cleaning filament between “spec...

In forum General discussion, announcements and releases

1 day ago
Not cleaning the hotend out after switch filaments. CF can ...

In forum General discussion, announcements and releases

1 day ago
The Creality CR6 sounds good on paper. I read the descripti...

In forum General discussion, announcements and releases

1 day ago
@dan-p12 Selling what on eBay?

In forum How do I print this? (Printing help)

2 days ago
can you post a build thread?

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 days ago
Please keep us updated.

In forum Hardware, firmware and software help

2 days ago
I get this on occasion. The last time I got it, I used clea...

In forum Assembly and first prints troubleshooting

2 days ago
Page 1 / 168
Share:

Please Login or Register