|
@oregonerd For the scored rods, there were some early MK3 un... In forum Hardware, firmware and software help |
3 years ago |
|
There are three parts from the MK3S+ that the MMU2S (for MK3... In forum Hardware, firmware and software help |
3 years ago |
|
That's worse... If it's blowing that fuse, the power supply ... In forum Hardware, firmware and software help |
3 years ago |
|
Which fuse is blowing? This page should give you an idea of ... In forum Hardware, firmware and software help |
3 years ago |
|
Definitely lubricate your bearings. Not only does it keep t... In forum General discussion, announcements and releases |
3 years ago |
|
The rubber is intended to seal the bearing from picking up d... In forum Hardware, firmware and software help |
3 years ago |
|
I pulled them from the source code here:/p> The relevant lin... In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
The firmware limits for the MK3S/S+ are 0 to 255 on X, -4 to... In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
Your X axis is running backwards. [0,0] should be on the fr... In forum Hardware, firmware and software help |
3 years ago |
|
Z is often going to be the hardest to get perfect accuracy w... In forum Hardware, firmware and software help |
3 years ago |
|
As long as you don't mind printing a full set, and adapting ... In forum Hardware, firmware and software help |
3 years ago |
|
@lex Last time the motors needed to be swapped was the MK0/1... In forum Hardware, firmware and software help |
3 years ago |
|
@joantabb You're right. My mistake. In forum Hardware, firmware and software help |
3 years ago |
|
@3dprinterguy9134 I was having some similar problems after i... In forum Assembly and first prints troubleshooting |
3 years ago |
|
I did the opposite with MK2.5-ish hardware in a MK3 frame, a... In forum Hardware, firmware and software help |
3 years ago |
|
The best way I've seen to cleaning out a nozzle before repla... In forum User mods - OctoPrint, enclosures, nozzles, ... |
6 years ago |
|
Be careful when removing a nozzle: cracked heater block In forum User mods - OctoPrint, enclosures, nozzles, ... |
6 years ago |
|
That is actually a pretty good idea.
Does anyone know what t... In forum Others (Archive) |
7 years ago |
|
MK2 electronics enclosure for Mini Rambo 1.0a In forum Improvements (Archive) |
8 years ago |
