Activity
 
k7zpj
k7zpj
Group: Registered
Joined: 2018/01/28
Estimable Member
4
The RPi 4B 8gb is a 64 bit board and takes a different Octpi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
I am using a Pimoroni Fan Shim to cool the RPI 4B 2 gb that ...

In forum General discussion, announcements and releases

4 months ago
Both the Mini and the MK3s are really good printers. Being y...

In forum General discussion, announcements and releases

5 months ago
@bruce-1 Did you check the status of the filament sensor in ...

In forum Hardware, firmware and software help

5 months ago
@ray-b2 Firmware version 3.90 enables the cutter and gives y...

In forum General discussion, announcements and releases

5 months ago
@smoking_rubber The Pi3B+ will be fine. You just install ...

In forum General discussion, announcements and releases

5 months ago
@mssj I use the DIY canvas hub instead of the pre-loaded on...

In forum General discussion, announcements and releases

5 months ago
@mssj Disable the filament sensor in firmware. Detach the MM...

In forum General discussion, announcements and releases

5 months ago
Voxel Factory: Printed Solid:

In forum General discussion, announcements and releases

6 months ago
@vintagepc The voltage is staying stable at 3.85V and doesn'...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
@3d-gussner I am having mixed results. Using 1K of resist...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
No filament: 4.4V filament: 0.4V Firmware version 3.9.0-RC3 ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
@ilja-coveliers Check the prusaprinters world map to see if ...

In forum General discussion, announcements and releases

6 months ago
The part numbers are in the description of this link or you ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
@avarax I would use the RPI 3B+ or RPI4B. If you want to...

In forum General discussion, announcements and releases

6 months ago
The Raspberry Pi Zero W has less processor power, less memor...

In forum General discussion, announcements and releases

6 months ago
@hmm You can make 3d prints hold water using an 3d-printing ...

In forum General discussion, announcements and releases

6 months ago
With Fusion 360 you can save all of the .stls files at once ...

In forum General discussion, announcements and releases

7 months ago
I would buy the MK3s now and learn how it works. I would wa...

In forum General discussion, announcements and releases

7 months ago
@matteo-cristini Congratulations on finally getting your pri...

In forum General discussion, announcements and releases

7 months ago
Page 1 / 8
Share:

Please Login or Register