bobstro
bobstro
Group: Registered
Joined: 2017/12/31
Illustrious Member
Ah yes, cooling thresholds. Sorry, I was thinking controllin...

In forum How do I print this? (Printing help)

12 hours ago
Simplest for what you specifically want to do (ensure consis...

In forum How do I print this? (Printing help)

13 hours ago
@neophyl has you on the right track. Variable Layer Heights ...

In forum PrusaSlicer

14 hours ago
@charles-h13 - I suspect you're going to find that your extr...

In forum General discussion, announcements and releases

14 hours ago
You are likely seeing the effect of small variation in speed...

In forum How do I print this? (Printing help)

15 hours ago
Flip the view around and see if those layers correspond to t...

In forum PrusaSlicer

2 days ago
In my mind, the STEP file is much like a python file produce...

In forum General discussion, announcements and releases

2 days ago
If that's your result from the sample pre-generated gcode fi...

In forum How do I print this? (Printing help)

2 days ago
This is where I'm not understanding what you're after. I can...

In forum General discussion, announcements and releases

2 days ago
A few quick notes: PETG is prone to absorbing moisture. Try ...

In forum Assembly and first prints troubleshooting

2 days ago
Just to add a data point: I've had no problems since install...

In forum Hardware, firmware and software help

2 days ago
Some of this is no doubt repetitive for you, but hopefully u...

In forum Hardware, firmware and software help

2 days ago
The online docs do a good job of referring to previous versi...

In forum General discussion, announcements and releases

2 days ago
Which 3D printer manufacturers or 3D printer designers are r...

In forum General discussion, announcements and releases

2 days ago
As you do your tests, focus on where the transition occurs. ...

In forum PrusaSlicer

2 days ago
Was following along thinking I might get into woodworking un...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
Rafts are essentially support, and supports in PrusaSlicer a...

In forum PrusaSlicer

3 days ago
Before tearing anything up, I'd contact support via online c...

In forum Hardware, firmware and software help

3 days ago
Doh! OK I was on mobile in the middle of a power outage. Tho...

In forum General discussion, announcements and releases

3 days ago
ugh - Can't print a first layer lower than 0.15mm.

In forum PrusaSlicer

3 days ago
Page 1 / 262
Share:

Please Login or Register