bobstro
bobstro
Group: Registered
Joined: 2017/12/31
Illustrious Member
Sounds like it was working fine at one point, so if you have...

In forum Assembly and first prints troubleshooting

6 hours ago
I don't personally. I've found that calibrating the extrusio...

In forum PrusaSlicer

10 hours ago
Ah yes, cooling thresholds. Sorry, I was thinking controllin...

In forum How do I print this? (Printing help)

1 day ago
Simplest for what you specifically want to do (ensure consis...

In forum How do I print this? (Printing help)

1 day ago
@neophyl has you on the right track. Variable Layer Heights ...

In forum PrusaSlicer

1 day ago
@charles-h13 - I suspect you're going to find that your extr...

In forum General discussion, announcements and releases

1 day ago
You are likely seeing the effect of small variation in speed...

In forum How do I print this? (Printing help)

1 day ago
Flip the view around and see if those layers correspond to t...

In forum PrusaSlicer

2 days ago
In my mind, the STEP file is much like a python file produce...

In forum General discussion, announcements and releases

2 days ago
If that's your result from the sample pre-generated gcode fi...

In forum How do I print this? (Printing help)

2 days ago
This is where I'm not understanding what you're after. I can...

In forum General discussion, announcements and releases

2 days ago
A few quick notes: PETG is prone to absorbing moisture. Try ...

In forum Assembly and first prints troubleshooting

2 days ago
Just to add a data point: I've had no problems since install...

In forum Hardware, firmware and software help

2 days ago
Some of this is no doubt repetitive for you, but hopefully u...

In forum Hardware, firmware and software help

2 days ago
The online docs do a good job of referring to previous versi...

In forum General discussion, announcements and releases

2 days ago
Which 3D printer manufacturers or 3D printer designers are r...

In forum General discussion, announcements and releases

3 days ago
As you do your tests, focus on where the transition occurs. ...

In forum PrusaSlicer

3 days ago
Was following along thinking I might get into woodworking un...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
Rafts are essentially support, and supports in PrusaSlicer a...

In forum PrusaSlicer

3 days ago
Before tearing anything up, I'd contact support via online c...

In forum Hardware, firmware and software help

3 days ago
Page 1 / 262
Share:

Please Login or Register