Notifications
Clear all
bobstro
bobstro
Group: Registered
Joined: 2017/12/31
Illustrious Member
PrusaSlicer was originally based on Slic3r which was largely...

In forum PrusaSlicer

2 years ago
This is essentially what the power save feature on the Mk3 d...

In forum General software discussion

2 years ago
You bring up a key point. I have no idea why someone would n...

In forum Hardware, firmware and software help

2 years ago
By all means, if you: Are running relatively current har...

In forum Hardware, firmware and software help

2 years ago
As with all things subjective, use what you prefer and can g...

In forum General discussion, announcements and releases

2 years ago
Ah, I found the link to the testing video. tl;dr starts here...

In forum General discussion, announcements and releases

2 years ago
You're getting push (bite) back because many of us have been...

In forum General discussion, announcements and releases

2 years ago
I do my cold pull with cleaning filament as the last step. L...

In forum General discussion, announcements and releases

2 years ago
A cold pull is done at temperatures well below typical print...

In forum General discussion, announcements and releases

2 years ago
Look for the result that most resembles the part as it appea...

In forum Assembly and first prints troubleshooting

2 years ago
The average person asking for help on these forums is not. R...

In forum Hardware, firmware and software help

2 years ago
I enjoy being part of the "Maker" community doing 3D printin...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
@netpackrat - Glad it's helpful! Careful: Tweaking gcode can...

In forum General discussion, announcements and releases

2 years ago
@azxciv -- Sorry, I've been tied up recently starting a new ...

In forum Assembly and first prints troubleshooting

2 years ago
@marka - I've been out of the loop for a bit pending a new j...

In forum General discussion, announcements and releases

2 years ago
This! A thousand times this! The main reason rafts were used...

In forum PrusaSlicer

2 years ago
If you look at the product descriptions from the various fil...

In forum Awesome prints (Hall Of Fame)

2 years ago
I've had issues with this in the past. Before writing this r...

In forum PrusaSlicer

2 years ago
FWIW - Recommendations for drying PETG are more like 65C fro...

In forum Assembly and first prints troubleshooting

2 years ago
This isn't a criticism. Just a bit of advice based on my own...

In forum General discussion, announcements and releases

2 years ago
Page 2 / 427
Share: