bobstro
bobstro
Group: Registered
Joined: 2017/12/31
Illustrious Member
I recommend doing a quick Live-Z recalibration any time you ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 hours ago
My understanding is that the Mk3 firmware is pushing the lim...

In forum Hardware, firmware and software help

5 hours ago
No issues with PrusaSlicer 2.3 Alpha 2 on Mojave on a 2014 1...

In forum PrusaSlicer

5 hours ago
Just to confirm: You are running PrusaSlicer (2.2, 2.3?) and...

In forum PrusaSlicer

13 hours ago
Looking at your S3D result, I'd say your Live-Z is too high....

In forum PrusaSlicer

13 hours ago
With a larger nozzle and increased layer heights, this is ac...

In forum PrusaSlicer

1 day ago
One thing that will impact that sort of print is the fact th...

In forum PrusaSlicer

2 days ago
It is a kit build, so I don't think a bit of additional cali...

In forum Hardware, firmware and software help

2 days ago
I had pretty much the same experience. In my case, it was Jo...

In forum General discussion, announcements and releases

2 days ago
TriangleLab makes good stuff, so hopefully just an anomaly. ...

In forum Hardware, firmware and software help

2 days ago
I also had an SD slot failure. Prusa shipped a replacement L...

In forum Assembly and first prints troubleshooting

2 days ago
FWIW: I have had good luck with larger (32, 64GB) cards when...

In forum Hardware, firmware and software help

2 days ago
@charles-h13 - FYI - I ordered a TriangleLab bimetal heatbre...

In forum Hardware, firmware and software help

2 days ago
Do the nut & bolt printed on the Prusa fit together prop...

In forum Hardware, firmware and software help

3 days ago
Your Live-Z value is too low (too negative). The nozzle is s...

In forum Assembly and first prints troubleshooting

3 days ago
My cheap IR thermometer is convinced my body temperature is ...

In forum Hardware, firmware and software help

3 days ago
Another point... looking at the pic on the left, it looks li...

In forum General discussion, announcements and releases

3 days ago
The layer immediately atop the bridge layer when using suppo...

In forum General discussion, announcements and releases

3 days ago
What is most likely happening is that the nozzle is being lo...

In forum General discussion, announcements and releases

3 days ago
To a point. The slicer can only print lines so thin, and exa...

In forum PrusaSlicer

3 days ago
Page 1 / 288
Share:

Please Login or Register