bobstro
bobstro
Group: Registered
Joined: 2017/12/31
Famed Member
When you say the filament "curled back on the nozzle", do yo...

In forum Assembly and first prints troubleshooting

2 hours ago
PrusaSlicer has a variable layer height feature. In layout m...

In forum General discussion, announcements and releases

2 hours ago
Best would be to save a 3MF project file, zip it up and uplo...

In forum PrusaSlicer

6 hours ago
Sounds like adhesion and/or Live-Z calibration. Notes here.

In forum General discussion, announcements and releases

6 hours ago
I can send files directly to a configured FlashAir card afte...

In forum PrusaSlicer

6 hours ago
You can use some thin wire to hold the sock in place. They d...

In forum General discussion, announcements and releases

6 hours ago
You might also try Print Settings->Layers and perimeters-...

In forum PrusaSlicer

9 hours ago
Good job. I wasn't aware of the reverse screws, will have to...

In forum Hardware, firmware and software help

9 hours ago
Ah, forgot that was coming. Just tested with PrusaSlicer 2.2...

In forum PrusaSlicer

9 hours ago
I think part of the problem was Prusa ramping up and (presum...

In forum Assembly and first prints troubleshooting

9 hours ago
Glad the notes are useful. Let me know if spot any issues!

In forum Assembly and first prints troubleshooting

9 hours ago
You've got some warping on the all-in-one test, most likely ...

In forum Hardware, firmware and software help

9 hours ago
If you configure printing via Octoprint, queued jobs will ap...

In forum PrusaSlicer

18 hours ago
Those appear to be recommended settings for Simplify 3D. S3D...

In forum How do I print this? (Printing help)

1 day ago
If you're in the US, you can get most spare parts at either ...

In forum Hardware, firmware and software help

1 day ago
Listen guys, they're working so hard they're over-drawing th...

In forum General discussion, announcements and releases

1 day ago
The gods punish arrogance. When my textured sheet arrived, I...

In forum Hardware, firmware and software help

1 day ago
A small concrete paver work as well. Cheap as dirt. I've got...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 day ago
I patched mine with a bit of blue tape to fill in an actual ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 day ago
Here's a PETG print I did using those settings: I didn't dr...

In forum How do I print this? (Printing help)

2 days ago
Page 1 / 195
Share:

Please Login or Register