Prusa3D Forum

Notifications

Clear all

bob.s

Group: Registered

Joined: 2016/11/02

Eminent Member

	Just adding to what nikolai and PJR have stated:.. I get al... In forum Others (Archive)	5 years ago
	I am trying to figure out the maximum print speed for PLA on... In forum Others (Archive)	5 years ago
	So, finally getting back to this. I printed mine standing u... In forum Awesome prints (Hall Of Fame)	7 years ago
	Very helpful. Thank you. In forum Assembly and first prints troubleshooting	7 years ago
	Thanks for you suggestions. I have changed filament with no... In forum Others (Archive)	7 years ago
	Extrusion failure In forum Others (Archive)	7 years ago
	Print Challenge In forum Awesome prints (Hall Of Fame)	7 years ago
	Thanks everyone! I feel really dumb. 😳 It was the li... In forum Print tips (Archive)	7 years ago
	I can't print Marvin anymore (Mk2) In forum Print tips (Archive)	7 years ago
	In an enclosure? No. There is no enclosure, but also no dra... In forum Others (Archive)	7 years ago
	Flaky bed temperature In forum Others (Archive)	7 years ago
	Good idea. By the way if you are a developer on the Prusa... In forum Improvements (Archive)	7 years ago
	For anyone following this thread, there's a happy ending! I... In forum Improvements (Archive)	7 years ago
	Initial Z coordinate In forum Prusa i3 kit (Archive)	7 years ago
	I used a PT100 temperature table that I found here: to do t... In forum Improvements (Archive)	7 years ago
	I have spent quite a bit of time figuring out about PT100 an... In forum Improvements (Archive)	7 years ago
	Peter, thanks for the confirmation that I am not alone here.... In forum Software (Archive)	7 years ago
	Sorry if I offended anyone. What I observed was a substan... In forum Software (Archive)	7 years ago
	Hello, I too am trying to interface a PT100 to the Rambo, bu... In forum Improvements (Archive)	7 years ago
	I figured this out. I was using firmware that I built from ... In forum Assembly and first prints troubleshooting	7 years ago

Page 1 / 2 Next

Forum Statistics

535 Forums

59.4 K Topics

425.8 K Posts

13 Online

63.8 K Members

Latest Post: High-temp iron infused filament? Our newest member: GreenyMeanie Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed