Ben Park
Ben Park
Group: Registered
Joined: 2018/09/24
Active Member
1
With my X & Y above the 280 mark as explained above, I a...

In forum Hardware, firmware and software help

9 months ago
I have not been around when the print stops. Since it is ran...

In forum Hardware, firmware and software help

9 months ago
Adjust X, re-executed selftest x=280, y=295

In forum Hardware, firmware and software help

9 months ago
I don't understand why the X & Y belt tensions matter (f...

In forum Hardware, firmware and software help

9 months ago
Crash detection is enabled. Zero crashes under the statistic...

In forum Hardware, firmware and software help

9 months ago
Forgot to mention... STL file has no recognized errors. I al...

In forum Hardware, firmware and software help

9 months ago
gautam-j and I have the same or similar issues. I am posting...

In forum Hardware, firmware and software help

9 months ago
First, I'm almost positive we can rule out the Octoprint. Th...

In forum Hardware, firmware and software help

9 months ago
You have some good suggestions from above. Clean the PEI pl...

In forum How do I print this? (Printing help)

11 months ago
I've had to take my MK3s hotend apart about 6-8 times now si...

In forum Assembly and first prints troubleshooting

11 months ago
What you did is correct. For reverting, from my experience, ...

In forum Hardware, firmware and software help

11 months ago
OK, so let me apologize for my rant. No-one needed it. The M...

In forum Print tips (Archive)

11 months ago
I have a similar problem with frequent filament jams. Since ...

In forum Print tips (Archive)

11 months ago
Mr Prusa whom I have tremendous respect should know he is lo...

In forum General discussion, announcements and releases

12 months ago
When can I stop working on converting my Tevo Black Widow an...

In forum General discussion, announcements and releases

12 months ago
Share:

Please Login or Register