Notifications
Clear all
Antoninus
Antoninus
Group: Registered
Joined: 2020/07/04
Eminent Member
2
I know... But when you want to use the MMU you have to use i...

In forum PrusaSlicer

4 years ago
version 2.2.0+win64

In forum PrusaSlicer

4 years ago
With support - bad object surface - mysterious gap

In forum PrusaSlicer

4 years ago
MK3S - XYZ Kalibrierung - XY "leicht schräg"

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

4 years ago
I'm not the only one who asks & needs a print to take wi...

In forum General discussion, announcements and releases

4 years ago
MMU2S -assembly- manual to print is missing!!! We all sure ...

In forum General discussion, announcements and releases

4 years ago
Perhaps a look into the ini files can help. See end of file....

In forum PrusaSlicer

4 years ago
.....G1 Z0.350 F7800.000G1 E-6.00000 F3960.00000G92 E0G1 Z0....

In forum PrusaSlicer

4 years ago
blue = with cura - goodyellow = ps 2.2 - with extrusion widt...

In forum PrusaSlicer

4 years ago
I switched to Reprap/Sprinter and see no difference G1 Z0.10...

In forum PrusaSlicer

4 years ago
@neophyl Oh yes I made a lot of with cura and the difference...

In forum PrusaSlicer

4 years ago
RE: Infill at curves - step by step - no line.

In forum PrusaSlicer

4 years ago
Ya!Found it. print settings / adv / I changed all the extrus...

In forum PrusaSlicer

4 years ago
Infill at curves - step by step - no line.

In forum PrusaSlicer

4 years ago
Thank you! I understand.Especially for beginners it is bette...

In forum PrusaSlicer

4 years ago
I must say correctly: the on-op support at the picture, in t...

In forum PrusaSlicer

4 years ago
See the first picture. That's new to me that a slicer puts s...

In forum PrusaSlicer

4 years ago
Brim - much too much

In forum PrusaSlicer

4 years ago
Sorry aber nur weil bei mir "New Member" steht stelle ich mi...

In forum Wie drucke ich das? (Hilfe zum Drucken)

4 years ago
🙂 Sterne haben in Foren wenig Bedeutung... Da kann man gan...

In forum Wie drucke ich das? (Hilfe zum Drucken)

4 years ago
Page 2 / 3
Share: