Notifications
Clear all
Antoninus
Antoninus
Group: Registered
Joined: 2020/07/04
Eminent Member
2
Hi! Does that mean estimated print time is not the same as...

In forum Input Shaper (MK4)

6 months ago
It happens with every filament we use, and we use a lot, and...

In forum Assembly and first prints troubleshooting

9 months ago
...to say correctly, before the print starts.

In forum Assembly and first prints troubleshooting

9 months ago
The latest update does not solve the issue. No matter what f...

In forum Assembly and first prints troubleshooting

9 months ago
Took 2 days with a MK3S for me. Have fun!

In forum Assembly and first prints troubleshooting

10 months ago
Heat the bed BEFORE leveling makes sense. It's better under ...

In forum Assembly and first prints troubleshooting

10 months ago
The leveling is inside the MK4 firmware. You see it when y...

In forum Assembly and first prints troubleshooting

10 months ago
Yes, but not Mk3 (message from prusa), only MK3S or + with o...

In forum General discussion, announcements and releases

10 months ago
Mk3S or + w/MMU2 does not touch the sheet during Z calibrati...

In forum Assembly and first prints troubleshooting

10 months ago
I got as answer: available soon, no download link

In forum Assembly and first prints troubleshooting

10 months ago
Always unwanted filament on noozle & sheet

In forum Assembly and first prints troubleshooting

10 months ago
I noticed that, too. Question is where is that option to tur...

In forum General discussion, announcements and releases

10 months ago
I updated a MK3S, 100% original, no octoprint or other stuff...

In forum General discussion, announcements and releases

1 year ago
Du hast noch einiges zu lernen... das kommt aber mit dem Alt...

In forum Hilfe zur Hardware, Firmware und Software

3 years ago
PC Blend gedruckt - Drucker defekt - Support Null

In forum Hilfe zur Hardware, Firmware und Software

3 years ago
Bad surface above support, bug or wanted? w/picture - Josef,...

In forum PrusaSlicer

3 years ago
No! forum.prusa3d.com is the place for prusaslicer. You can ...

In forum PrusaSlicer

3 years ago
The prusaslicer effect: Use the layer view /preview. Look at...

In forum PrusaSlicer

4 years ago
Joan, Hi, I bought a Prusa + MMu2S.And have to use Prusaslic...

In forum PrusaSlicer

4 years ago
That doesn't change anything, the gap between the first-laye...

In forum PrusaSlicer

4 years ago
Page 1 / 3
Share: