|
Hello, with the current competition with China, PRUSA have t... In forum General discussion, announcements and releases |
2 weeks ago |
|
- Are you using the original PRUSA USB dongle ? In forum Hardware, firmware and software help |
3 weeks ago |
|
No, it does not work. The FlashAir is not supported on the M... In forum Hardware, firmware and software help |
3 weeks ago |
|
Hello, I had the same issue and lost an afternoon with PRUSA... In forum General discussion, announcements and releases |
3 weeks ago |
|
I took something similar. Unfortunately just after the purch... In forum User mods, enclosures, nozzles, ... |
1 month ago |
|
I built several dry boxes, all around. You can do the same, ... In forum User mods, enclosures, nozzles, ... |
1 month ago |
|
@eastcoastjoe let me understand: how did you save the bgcode... In forum PrusaSlicer |
1 month ago |
|
My suggestions/checks:
1) Ensure your filament from the ex... In forum Assembly and first prints troubleshooting |
1 month ago |
|
- Are you using the 60W 3.5 FW on a 60W REVO heater ? It see... In forum Assembly and first prints troubleshooting |
1 month ago |
|
Good to know. I have purchased the 60W version because when ... In forum User mods, enclosures, nozzles, ... |
1 month ago |
|
I received mine with MMU3 cable yesterday.
I will install ... In forum General discussion, announcements and releases |
1 month ago |
|
I don't think I will move to Klipper any more. I just purcha... In forum User mods - OctoPrint, enclosures, nozzles, ... |
1 month ago |
|
Finally, they are shipping now my MK3.5 KIT and (I hope) the... In forum General discussion, announcements and releases |
2 months ago |
|
- Do you have an MMU connected ? I say this because I have, ... In forum Hardware, firmware and software help |
2 months ago |
|
Yes, do not forget to order the special cable for the MMU3. ... In forum General discussion, announcements and releases |
2 months ago |
|
I have just ordered from E3D also the 60W version of the REV... In forum General discussion, announcements and releases |
2 months ago |
|
@Doubledutch Already ordered 😊 In forum General discussion, announcements and releases |
2 months ago |
|
Yes, it was for me. It was a matter of fine tuning the MK3/S... In forum General discussion, announcements and releases |
2 months ago |
|
I just spoke with PRUSA support and they confirmed that for ... In forum General discussion, announcements and releases |
2 months ago |
|
MK3.5 Upgrade kit do NOT support REVO FastChange In forum General discussion, announcements and releases |
2 months ago |
