Notifications
Clear all
ANTALIFE
ANTALIFE
Group: Registered
Joined: 2018/01/23
Trusted Member
3
Oh good catch! Contacted Molex and looks like they don't do ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
The circled orange block below? Not mine, I think this was f...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Where are you hoping to move the sensors to? I was thinking ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Don't forget you can also buy pre-assembled cables:

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Thanks heaps 😍

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
I see you have taken the side filament sensor apart 😀 Cou...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
RE:

In forum General discussion, announcements and releases

10 months ago
Closeups of side filament sensor board?

In forum Hardware, firmware and software help

10 months ago
@greg-whitehead

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
@jsw Yea printing with those two is not an issue, I am talki...

In forum General discussion, announcements and releases

3 years ago
Had this issue as well, changed the printer FW to handle it ...

In forum Hardware, firmware and software help

3 years ago
I found that using a E3D v6 Pro Sock (the one that covers th...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Get a dual hotend printer and print with something like ABS/...

In forum How do I print this? (Printing help)

3 years ago
Something I found is that printing with multiple materials (...

In forum General discussion, announcements and releases

3 years ago
You want to use Dribbling variant of Prusaslicer. Am on my p...

In forum Hardware, firmware and software help

3 years ago
Yea you need to have crazy purge volumes if you want to have...

In forum How do I print this? (Printing help)

3 years ago
Sounds like your printer would still be under warranty, best...

In forum Hardware, firmware and software help

4 years ago
@fionnbharre-s2 No problemoAh yup, I see what you are trying...

In forum General discussion, announcements and releases

4 years ago
I know your pain, and after doing heaps of tests I concluded...

In forum How do I print this? (Printing help)

4 years ago
Have not printed with that PVA before, but here is what I ha...

In forum General discussion, announcements and releases

4 years ago
Page 1 / 4
Share: