Activity
 
Andrew
Andrew
Group: Registered
Joined: 2020/04/08
Estimable Member
4
Sorry, video/recording won't play. Can you try again.

In forum Assembly and first prints troubleshooting

3 months ago
It shouldn't be hard, although it can be frustrating. First...

In forum Assembly and first prints troubleshooting

3 months ago
It's not the 40deg in the enclosure softening the PLA it's h...

In forum How do I print this? (Printing help)

3 months ago
Oh, and try to avoid using the rounded end of the allan key ...

In forum Hardware, firmware and software help

3 months ago
Only way would be to drill and try reverse tap (if you have ...

In forum Hardware, firmware and software help

3 months ago
Last update on this one from me. Memory upgrade failed (moth...

In forum General discussion, announcements and releases

4 months ago
Heating to 250? I will assume you are printing PLA (if its P...

In forum Hardware, firmware and software help

4 months ago
I would advise against it purely on the basis that most dish...

In forum General discussion, announcements and releases

4 months ago
I'm not sure why it's better in one direction than the other...

In forum General discussion, announcements and releases

4 months ago
Can you give a bit more detail please. What filament, what t...

In forum General discussion, announcements and releases

4 months ago
The issue could be an error in the way its being interpreted...

In forum PrusaSlicer

4 months ago
@riccardo-ravicini Do not apologise for a long explanation. ...

In forum PrusaSlicer

4 months ago
@flo-r No need to apologise. I agree on the cheep nozzles. I...

In forum General discussion, announcements and releases

4 months ago
@charles-h13 Nice. I didn't see these on amazon UK. Will hav...

In forum General discussion, announcements and releases

4 months ago
@gordon-w No those are too fierce for my liking. I used to h...

In forum General discussion, announcements and releases

4 months ago
I am unsure what you mean by on the long stipes. If you mean...

In forum PrusaSlicer

4 months ago
I use long needle nosed pliers to get the filament before it...

In forum General discussion, announcements and releases

4 months ago
Like Peter says the gear is on the wrong way round. I should...

In forum Hardware, firmware and software help

4 months ago
Thanks.

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Sorry. I missread your post. I thought it was a pin from the...

In forum Hardware, firmware and software help

4 months ago
Page 1 / 6
Share:

Please Login or Register