Activity
 
alvaro
alvaro
Group: Registered
Joined: 2019/11/12
Eminent Member
2
Turn off all your plug ins and try again. The time laps plu...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
Adjusting your settings to have a raft or a brim is the corr...

In forum Assembly and first prints troubleshooting

2 months ago
the layer issues were caused by a very loose table. The ooz...

In forum Assembly and first prints troubleshooting

2 months ago
The extrusion multiplier was spot on. The temp tower is pri...

In forum Assembly and first prints troubleshooting

2 months ago
The Ender 3 is a pile of parts and hopes and dreams. I don't...

In forum General discussion, announcements and releases

2 months ago
@robert-rmm200 Well it wont overheat, it will just throttle ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I think you have convinced me to just hang one on the 24v po...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I agree with the last post even though I powered it from the...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
sorry, 3 amps...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Just make sure you have clean and at least 2 amps of power t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I am wondering how many other printers have this issue. So,...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
I put the O-ring in there to take up all the play in the hot...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
File uploaded... I stretched this oring over the hot end no...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
That will come out very easily dont sweat it. There is nothi...

In forum Hardware, firmware and software help

2 months ago
Thanks for the advice. Will re-calibrate ASAP.

In forum Assembly and first prints troubleshooting

2 months ago
Complete E3D V6 hot end replacement test print - stringing

In forum Assembly and first prints troubleshooting

2 months ago
When I powered my Pi4 directly from the board I had serial t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Hot end mounted 90 degrees off - Thermistor and Heater exit ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
The Pi4 runs fine - the only drawback is less cases to choos...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
You should power it down from the octoprint web site. On th...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Page 1 / 2
Share:

Please Login or Register