Notifications
Clear all
Allanimal
Allanimal
Group: Registered
Joined: 2017/11/04
Eminent Member
2
Has the issue been fixed where we are observing blips in the...

In forum General discussion, announcements and releases

5 years ago
No plugin needed. It'll work when printing or idle. You need...

In forum General discussion, announcements and releases

5 years ago
I have noticed in the latest couple versions of Slic3r Prusa...

In forum General discussion, announcements and releases

5 years ago
How do I Fix these Printing Issues?

In forum How do I print this? (Printing help)

6 years ago
I sometimes see extrusion problems once a fresh filament spo...

In forum Hardware, firmware and software help

6 years ago
I sometimes see extrusion problems once a fresh filament spo...

In forum Hardware, firmware and software help

6 years ago
Thanks for your reply. I'll try your suggestions when I get ...

In forum Hardware, firmware and software help

6 years ago
Inconsistent Extrusion

In forum Hardware, firmware and software help

6 years ago
Log in at shop.prusa3d.com and you should see all the replac...

In forum Hardware, firmware and software help

6 years ago
When I slice something with PrusaControl (Mac, version 0.9.4...

In forum Hardware, firmware and software help

6 years ago
Compiled the latest firmware, this is my gcode. The printer ...

In forum Hardware, firmware and software help

6 years ago
Compiled the latest firmware, this is my gcode. The printer ...

In forum Hardware, firmware and software help

6 years ago
Attached. Thanks for providing this Brigandier! One questio...

In forum Others (Archive)

6 years ago
do the belt idlers turn smoothly, some folk over tighten th...

In forum Others (Archive)

6 years ago
XYZ Calibration Problem

In forum Others (Archive)

6 years ago
Great! Thanks! I was really worried I broke something. I gu...

In forum Others (Archive)

6 years ago
Great! Thanks! I was really worried I broke something. I gu...

In forum Others (Archive)

6 years ago
Where Does This Piece Go?

In forum Others (Archive)

6 years ago
No you do not need to remove the frame, just Z-axis-top left...

In forum Others (Archive)

6 years ago
Try to loosen the center screw for the X (and Y) end pulley....

In forum Others (Archive)

6 years ago
Page 1 / 2
Share: