|
Thanks Bobstro, Vorticle. The hotend is as built and supplie... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Thanks Peter, will do. It doesn't look like the leak is from... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
In the process of cleaning the head I have noticed what appe... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Thanks Peter, will try all this now. Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Assume I need to heat the head up? What's the best way to do... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Am guessing this the root of my problems.. Best tips on gett... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Thanks Peter. I will look at a 'deep clean' of nozzle and un... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Here's a (not very good) of a problem area starting to build... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
It's hard to say if a problem from the beginning, as it's on... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Hi Clemens, thank you for your response. I will check the no... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
PETG - lot's of crashes Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
I'm using the stock PETG settings in Slicer, looks like mini... Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Weak PETG print at higher Z levels Dans le forum General discussion, announcements and releases |
il y a 4 years |
|
Bingo! Fixed mine too. In my case I just had to undo the lit... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
I haven't had time to investigate mine yet, but if it is thi... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Thanks Joan. Your suggestion makes sense, as the dialogue on... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Insanely stupid newbie question.. Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
I am learning there is more to this business than meets the ... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
Thanks Joan. As i write this the printer is happily doing it... Dans le forum Hardware, firmware and software help |
il y a 4 years |
|
UPDATE It proved impossible to extract the broken filament f... Dans le forum Hardware, firmware and software help |
il y a 4 years |
