|
Attached is the S3D profile I've been running for general pr... In forum General discussion, announcements and releases |
6 years ago |
|
Attached is the S3D profile I've been running for general pr... In forum General discussion, announcements and releases |
6 years ago |
|
Attached is the S3D profile I've been running for general pr... In forum General discussion, announcements and releases |
6 years ago |
|
There should be an option to keep these changed settings AND... In forum General discussion, announcements and releases |
6 years ago |
|
Attached is the S3D profile I've been running for general pr... In forum General discussion, announcements and releases |
6 years ago |
|
So as a heads up, Prusa had sent me a new hotend and the sam... In forum Hardware, firmware and software help |
6 years ago |
|
All I can say is get on tech-support chat and also send a vi... In forum Hardware, firmware and software help |
6 years ago |
|
Had a similar issue. The extruder motor got a bit hot and pr... In forum Hardware, firmware and software help |
6 years ago |
|
Sounds like your clicking is tension based.
Nope. It's no... In forum Hardware, firmware and software help |
6 years ago |
|
Do you have a video showing the skipping? Is it like this? In forum Hardware, firmware and software help |
6 years ago |
|
Extruder starts clicking and not feeding right about an hour... In forum Hardware, firmware and software help |
6 years ago |
|
Turn off filament sensor to see if at least the clicking rem... In forum Hardware, firmware and software help |
6 years ago |
|
It's the filament sensor errors that are strange to me, so w... In forum Hardware, firmware and software help |
6 years ago |
|
Had that same exact issue with PLA. Turned up temp to 250 fo... In forum Hardware, firmware and software help |
6 years ago |
|
I just did a cold/atomic pull this morning after a print fin... In forum Hardware, firmware and software help |
6 years ago |
|
Had that same exact issue with PLA. Turned up temp to 250 f... In forum Hardware, firmware and software help |
6 years ago |
|
Using the profiles posted here my nozzle drags across my pri... In forum General discussion, announcements and releases |
6 years ago |
|
it s 3 days long i m loocking for the default steps per unit... In forum Hardware, firmware and software help |
6 years ago |
|
Can you explain what to do? Are you going to make a script t... In forum Hardware, firmware and software help |
6 years ago |
|
Printoid runs on Android phone but just remotely connects to... In forum Others (Archive) |
6 years ago |
