Notifications
Clear all
sam.d10
sam.d10
Group: Registered
Joined: 2018/12/07
Eminent Member
2
Did the new LCD come with cables, if so did you use them as ...

In forum General discussion, announcements and releases

1 year ago
Yes, you will then have to go through the setup wizard and c...

In forum Hardware, firmware and software help

1 year ago
Firstly the oozing when the printer is heating up is normal ...

In forum Assembly and first prints troubleshooting

1 year ago
Are you using gcode that came on the SD card as sometimes th...

In forum Assembly and first prints troubleshooting

1 year ago
Can you show some pictures please, this will allow us to see...

In forum Assembly and first prints troubleshooting

1 year ago
No problem, let’s hope that it works.

In forum General discussion, announcements and releases

1 year ago
Found this which is available in the uk, the only difference...

In forum General discussion, announcements and releases

1 year ago
I just found this if you are in the US here:

In forum General discussion, announcements and releases

1 year ago
Ok, I would say the the LCD is damaged, do you know if it ha...

In forum General discussion, announcements and releases

1 year ago
Is your X axis level? I have had some issues after working o...

In forum General discussion, announcements and releases

1 year ago
I’m guessing that the photo of the print is the top layer if...

In forum General discussion, announcements and releases

1 year ago
Have you tried to remove the thermistor whilst the hot-end i...

In forum General discussion, announcements and releases

1 year ago
If this happens every time then there could be a couple of t...

In forum General discussion, announcements and releases

1 year ago
Just check that your heater cartridge is 40W if it is it sho...

In forum Hardware, firmware and software help

2 years ago
I totally agree with @tim-m30

In forum General discussion, announcements and releases

2 years ago
Also I understand that you may just want to get the printer ...

In forum General discussion, announcements and releases

2 years ago
My first 3D printer was a M3D Micro which I will say was ok ...

In forum General discussion, announcements and releases

2 years ago
Maybe that is what happens when the estimated time runs out,...

In forum Hardware, firmware and software help

2 years ago
To do a multi colour print like that you would require a mul...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 2
Share: