Activity
 
Notifications
Clear all
jmone
jmone
Group: Registered
Joined: 2018/11/23
Reputable Member
5
Hi Clemens, Yes that was done be me, from printing to making...

In forum General software discussion

2 months ago
I just add supports and the knock out pretty cleanly.

In forum PrusaSlicer

2 months ago
Yup it works. Cast the 2D Cookie Stamp deign from the above...

In forum General software discussion

2 months ago
FYI - this looks promising just importing an image into MS 3...

In forum General software discussion

2 months ago
Thanks - this is what I feared.... and I'm not sure it will ...

In forum General software discussion

2 months ago
Sorry for the late replay, I missed you post! I have a rang...

In forum PrusaSlicer

2 months ago
Software to Extrude Down a 2D image with a Draft?

In forum General software discussion

2 months ago
No problems, it's all about the community helping each other...

In forum PrusaSlicer

4 months ago
The model printed well (I did not use supports, brims etc) a...

In forum PrusaSlicer

4 months ago
I've got your sample and I'm currently printing the Right Ca...

In forum PrusaSlicer

4 months ago
...actually, I'm not sure this will help as I had a look at ...

In forum PrusaSlicer

4 months ago
...if you post the STL, I'll print it on my setup and if it ...

In forum PrusaSlicer

4 months ago
Are the skipped layers always in the same place or is it ran...

In forum PrusaSlicer

4 months ago
I ran a multi month experiment (the thread is somewhere on t...

In forum PrusaSlicer

4 months ago
Doubt it. It really is very easy to print when fully dry. ...

In forum PrusaSlicer

4 months ago
I've printed many spools of ePA-CF (all eSun) and all I can ...

In forum PrusaSlicer

4 months ago
I'm not familiar with this brand of PA-CF but 8h in a Food D...

In forum PrusaSlicer

4 months ago
Sounds good

In forum PrusaSlicer

7 months ago
Good you have the dimensions down and working. I find that w...

In forum PrusaSlicer

7 months ago
@ffdez. There is a little Lock Icon in the scale factor, if...

In forum PrusaSlicer

7 months ago
Page 1 / 17
Share: