Activity
 
Notifications
Clear all
Andy
Andy
Group: Registered
Joined: 2018/11/19
Eminent Member
2
Just received the replacement LCD display with the new encod...

In forum Assembly and first prints troubleshooting

2 years ago
I've managed to resolve all my problems, and I am really hap...

In forum General discussion, announcements and releases

2 years ago
This is a great tip, and one that I think will solve the iss...

In forum General discussion, announcements and releases

2 years ago
@david-h8 I tried a small squirt of WD40 and it loosened eno...

In forum Assembly and first prints troubleshooting

2 years ago
These are all good advice and I’m now onto my 18th hour of p...

In forum Assembly and first prints troubleshooting

2 years ago
@towlerg See the Underextrusion thread in setup/first print ...

In forum General discussion, announcements and releases

2 years ago
I too have the textured and smooth sheet, the differences we...

In forum General discussion, announcements and releases

2 years ago
I have both. I have had zero issues with the MK3 and the upg...

In forum General discussion, announcements and releases

2 years ago
@brad-w2 Fantastic! I think this was my issue too. I also no...

In forum Assembly and first prints troubleshooting

2 years ago
Agreed, but I’m unable to do this until Prusa get back to me...

In forum Assembly and first prints troubleshooting

2 years ago
@chris-b2 At this point I’m not even able to unload the fila...

In forum Assembly and first prints troubleshooting

2 years ago
@chris-b2 I’m 100% in agreement. I’ve some different Bowden ...

In forum Assembly and first prints troubleshooting

2 years ago
@chris-b2 Yeah my MK3 is superb with anything. The Mini is v...

In forum Assembly and first prints troubleshooting

2 years ago
@chris-b2 Have you tried some different filament? I’m using ...

In forum Assembly and first prints troubleshooting

2 years ago
Mine has now completely gone and I snapped one of the "arms"...

In forum Assembly and first prints troubleshooting

2 years ago
Cold pull is worth a shot as Sigfredo suggests if not alread...

In forum Assembly and first prints troubleshooting

2 years ago
@chris-b2 I’ve had similar amounts of time invested and the ...

In forum Assembly and first prints troubleshooting

2 years ago
@chris-b2 I did notice some dust and strands of filament (an...

In forum Assembly and first prints troubleshooting

2 years ago
@chris-b2 Are you able to pull the hot end down or notice an...

In forum Assembly and first prints troubleshooting

2 years ago
@jockspice Check out the “under extrusion” topic. Some of us...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 2
Share: