Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
try disconnecting the mmu power and seeing if the problem pe...

In forum Hardware, firmware and software help

1 week ago
Try Againnutbox  nutbox-2.zip

In forum PrusaSlicer

1 week ago
I wash my build plate with Hot water and dish soap, rinse wi...

In forum How do I print this? (Printing help)

1 week ago
Is your 2.3.2, a full release, or a beta / release candidate...

In forum PrusaSlicer

1 week ago
those nut trap tops are likely to droop without supporthave ...

In forum PrusaSlicer

1 week ago
Could that have been caused by a thumb print on the corner o...

In forum How do I print this? (Printing help)

1 week ago
this is probably not the best approach to revising the value...

In forum General discussion, announcements and releases

1 week ago
the + adds a new Supa Pinda, and a revised filament sensor p...

In forum General discussion, announcements and releases

1 week ago
My 2.3.2 beta installation didn't Auto update, but My 2.3.1 ...

In forum PrusaSlicer

1 week ago
as you have changed the nozzle there is a chance that there ...

In forum How do I print this? (Printing help)

2 weeks ago
Good Luck!

In forum Assembly and first prints troubleshooting

2 weeks ago
Hi Chuck. I also had one of the perspex printers... It was 8...

In forum Assembly and first prints troubleshooting

2 weeks ago
The Mk3 has a 6mm aluminium main frame, and aluminium extrus...

In forum Assembly and first prints troubleshooting

2 weeks ago
Hi Ryan. how many teeth are there on the motor pully? I be...

In forum Assembly and first prints troubleshooting

2 weeks ago
Hi Ian and Stu, the Buildplate is held in place by Strong M...

In forum Hardware, firmware and software help

2 weeks ago
Model FULL SIZE, in Millimeters, and make sure that the line...

In forum PrusaSlicer

2 weeks ago
if you wish to change the thermistor wires, I would use 24AW...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 weeks ago
Hi GreatspudWas the model drawn in Inches? or was it really ...

In forum PrusaSlicer

2 weeks ago
Flexible silicone cables have higher conductor count than ot...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 weeks ago
I also enable 7x7 mesh bed levelling, and use Life adjust Z ...

In forum Assembly and first prints troubleshooting

2 weeks ago
Page 2 / 344
Share: