JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
@sannin Hi, are you using 7x7 mesh bed levelling? available...

In forum How do I print this? (Printing help)

2 weeks ago
use a good quality USB Cable, and PronterfaceOn your PC Clos...

In forum General discussion, announcements and releases

2 weeks ago
I use a TURBO Kitchen lighter, to heat the slot and push the...

In forum General discussion, announcements and releases

3 weeks ago
Could it be a reset switch?

In forum Hardware, firmware and software help

3 weeks ago
Is the printer 100% standard configuration? Can you attach a...

In forum Assembly and first prints troubleshooting

3 weeks ago
swap the polarity of the heatbed power wires at the Heatbed...

In forum Hardware, firmware and software help

3 weeks ago
have you got the X axis motor Toothed Pulley, installed back...

In forum Assembly and first prints troubleshooting

3 weeks ago
@kinghelmer Hi, I think you left 'Don't Support Bridges' ti...

In forum PrusaSlicer

3 weeks ago
@doofy Hi Doofy, If the V6 is assembled correctly, not havin...

In forum General discussion, announcements and releases

3 weeks ago
did the printer ask you to press the button to select the la...

In forum Hardware, firmware and software help

3 weeks ago
@wopas I heat the extruder to a high temperature then use a ...

In forum Hardware, firmware and software help

3 weeks ago
@3ddruckbertl you need to be in Advanced Mode, or Expert Mod...

In forum PrusaSlicer

3 weeks ago
Hi Doofy, what did you replace the heatbreak and nozzle with...

In forum General discussion, announcements and releases

3 weeks ago
RE: débutant

In forum Discussion générale, annonces et nouveautés

3 weeks ago
is it possible that you short circuited the 24 volt heater c...

In forum General discussion, announcements and releases

4 weeks ago
you could turn off Elephant's foot compensation, and use sat...

In forum How do I print this? (Printing help)

4 weeks ago
that is not an option that I am aware of... some folk monito...

In forum Discusión general, anuncios y lanzamientos

4 weeks ago
your belts could be loose, your extruder could be loose some...

In forum Wie drucke ich das? (Hilfe zum Drucken)

4 weeks ago
No shielding in Prusa LCD Cables. shielding would increase t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 weeks ago
Page 2 / 337
Share:

Please Login or Register