Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
Best wishesJoan

In forum Hardware, firmware and software help

8 hours ago
I think the mk8 screw thread is 6mm long, and the e3Dv6 nozz...

In forum User mods - OctoPrint, enclosures, nozzles, ...

8 hours ago
the power panic board, monitors the incoming power for probl...

In forum Hardware, firmware and software help

9 hours ago
did you change the nozzle? mk8 nozzles have a short thread o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

9 hours ago
the hotend was a bit loose Here you go. I realized the heati...

In forum Assembly and first prints troubleshooting

9 hours ago
it would be useful to have more info...try slicing for a 0.2...

In forum How do I print this? (Printing help)

16 hours ago
possibly ThwKKing-Tex would be more descriptive or Energet...

In forum General discussion, announcements and releases

16 hours ago
I believe this was discontinued by the designer, because oth...

In forum General discussion, announcements and releases

1 day ago
there are maximum parameters in firmware, which are compared...

In forum How do I print this? (Printing help)

3 days ago
can you try again with a lower value for the initial exposu...

In forum Hardware, firmware and software help

3 days ago
very likely you have a gap between the heatbreak and the noz...

In forum Hardware, firmware and software help

3 days ago
Hmmm... most of my prints are no pad, and no thump... I have...

In forum Hardware, firmware and software help

3 days ago
can you post this on Github please?regards Joan

In forum Hardware, firmware and software help

3 days ago
Prusa have a Chat service, on the bottom right hand corner o...

In forum Hardware, firmware and software help

3 days ago
are you using the SL1 Settings with an SL1s printer?

In forum Hardware, firmware and software help

3 days ago
can you measure the actual model height with a vernier calli...

In forum Hardware, firmware and software help

4 days ago
Page 1 / 351
Share: