Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
My laptop doesn't even have a Micro SD slot... using an SD a...

In forum Hardware, firmware and software help

1 day ago
Have you dot 'Don't Support Bridges' ticked?It's and Advance...

In forum How do I print this? (Printing help)

1 day ago
Have you run the Z axis all the way to the top so that both ...

In forum Hardware, firmware and software help

2 days ago
the recommended lubricant is white lithium soap, grease, as ...

In forum General discussion, announcements and releases

2 days ago
Maybe belts loose or toothed gears loose. Or idlers failing

In forum How do I print this? (Printing help)

2 days ago
I wash my buildplate, rinse and dry immediately, using plain...

In forum Assembly and first prints troubleshooting

2 days ago
Check that your motor pulley screws are set correctly, with ...

In forum Assembly and first prints troubleshooting

2 days ago
Precious learning point... you won't forget this|Good luck w...

In forum How do I print this? (Printing help)

2 days ago
Your walls are probably too thin. try a smaller nozzle, or t...

In forum PrusaSlicer

2 days ago
Hello Jack, Prusa Slicer doesn't allow 100% infill for most ...

In forum How do I print this? (Printing help)

3 days ago
Hello Jack... 100% infill has never been good for me... so w...

In forum How do I print this? (Printing help)

3 days ago
try unticking ensure vertical wall thickness and then re sli...

In forum PrusaSlicer

5 days ago
the sensor will be 5voltregards Joan

In forum Assembly and first prints troubleshooting

6 days ago
Chinese filament sensor kits are cheap enough on ebay or ali...

In forum Assembly and first prints troubleshooting

6 days ago
Good luck!I hope the supplier sorts this. regards Joan

In forum PrusaSlicer

1 week ago
I edited your last post to make the video visibleregards Jo...

In forum Hardware, firmware and software help

1 week ago
I have had PLA Items go soft in the sun...or on a radiator ...

In forum PrusaSlicer

2 weeks ago
Have you found the Prusa Knowledge base article on nozzle re...

In forum How do I print this? (Printing help)

2 weeks ago
I wash the buildplate with hot water and dish soap, Rinse we...

In forum Assembly and first prints troubleshooting

3 weeks ago
be very careful, ensure all ptfe crumbs are removed after ch...

In forum Hardware, firmware and software help

3 weeks ago
Page 1 / 358
Share: