JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
If you hadn't seen anything on Etsy and just designed it you...

In forum General discussion, announcements and releases

10 hours ago
Hi Alison, If the PTFE Won't cone out of thetop of the hoten...

In forum Hardware, firmware and software help

10 hours ago
Best wishes and Good LuckJoan

In forum How do I print this? (Printing help)

1 day ago
That is a tall model for a small contact patchwhat is your f...

In forum How do I print this? (Printing help)

1 day ago
@msw text can be a bit difficult to print, If the test stro...

In forum How do I print this? (Printing help)

2 days ago
Hi Rob, your picture is not showing. regards Joan

In forum How do I print this? (Printing help)

2 days ago
Have you tried the Configuration Wizard?

In forum PrusaSlicer

2 days ago
Pictures would be useful.If you are about 1cm low it it prob...

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

3 days ago
what does the bottom of the print look like? Regards Joan

In forum Assembly and first prints troubleshooting

3 days ago
the Prusa First layer calibration tool id not particularly e...

In forum How do I print this? (Printing help)

5 days ago
I was glad to get rid of the Glass on my Prusa Mk1... now al...

In forum PrusaSlicer

7 days ago
some people have had issues after graphics cards have been u...

In forum Discussion générale, annonces et nouveautés

1 week ago
Mintemp error is typically a loose connection, or broken wir...

In forum Hardware, firmware and software help

1 week ago
I would order, what was easily obtainable either 2.5 or 3, ...

In forum General discussion, announcements and releases

1 week ago
@alexsunny123 what was the fix? Joan

In forum Assembly and first prints troubleshooting

1 week ago
could you save a copy of your slicer setup, in a project fil...

In forum How do I print this? (Printing help)

1 week ago
Mk3S to MMU2 was pretty much rebuild extruder to have a sens...

In forum Assembly and first prints troubleshooting

1 week ago
Hi Colin, you could put a raft under the supports which chou...

In forum PrusaSlicer

2 weeks ago
that looks like a clone of an early Prusa. what controller b...

In forum Anciennes machines (Prusa i3 MK1 et prédécesseurs)

2 weeks ago
@barney15e My Mistake, it's a mini not a mk3. if the heater ...

In forum Hardware, firmware and software help

2 weeks ago
Page 1 / 338
Share:

Please Login or Register