Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
Did you set the extrusion widths to match the larger nozzle?...

In forum PrusaSlicer

3 weeks ago
does the X axis move smoothly by hand, in both directions? r...

In forum Hardware, firmware and software help

3 weeks ago
what is the weight of your failed print? is it around 1kg? r...

In forum General discussion, announcements and releases

3 weeks ago
Hi Leo, what sort of models are you looking for?Here are som...

In forum General discussion, announcements and releases

3 weeks ago
Cheers Edgar, Good luck with the new wiresregards Joan

In forum Assembly and first prints troubleshooting

3 weeks ago
Hi Edgar, the Heatbed power wires can fail intermittently op...

In forum Assembly and first prints troubleshooting

3 weeks ago
that looks as if Live Z is not set properly, the nozzle look...

In forum Hardware, firmware and software help

3 weeks ago
DONT FORGET TO RESET LIVE Z to ZERO, before doing these upgr...

In forum General discussion, announcements and releases

3 weeks ago
hmmm.... Curious!

In forum Hardware, firmware and software help

3 weeks ago
Is it the bundled filament that you are referring to? If the...

In forum General discussion, announcements and releases

3 weeks ago
My Pleasure, did it improve your first layer?Joan

In forum How do I print this? (Printing help)

3 weeks ago
Have the bearings been greased recently If not try greasing ...

In forum Hardware, firmware and software help

3 weeks ago
Are the smooth rails seated properly in the Y axis rail cups...

In forum Hardware, firmware and software help

3 weeks ago
Are you using 3x3 mesh bed levelling, or 7x7 mesh bed levell...

In forum How do I print this? (Printing help)

4 weeks ago
Addidional to neophyl's comments. Heat significantly softens...

In forum How do I print this? (Printing help)

4 weeks ago
If its for business. Is it really a toy? 🙂 Remember there ...

In forum How do I print this? (Printing help)

4 weeks ago
If its for business. Is it really a toy? 🙂 Remember there ...

In forum How do I print this? (Printing help)

4 weeks ago
is the double funnel easier to use than a single funnel? do...

In forum How do I print this? (Printing help)

4 weeks ago
May I ask, what it's for? Joan

In forum How do I print this? (Printing help)

4 weeks ago
you cannot add STL files directly to the forum, But if you Z...

In forum How do I print this? (Printing help)

4 weeks ago
Page 3 / 355
Share: