Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
Ah, less repairable! sorry. regards Joan

In forum Hardware, firmware and software help

6 hours ago
there is a fuse in the input socket, between the IEC Plug ho...

In forum Hardware, firmware and software help

7 hours ago
when you changed to the Mk3 Extruder, did you change the fir...

In forum Obecná diskuze, oznámení a novinky

15 hours ago
Hi Darryll, stepper motors are able to generate electricity,...

In forum Hardware, firmware and software help

15 hours ago
try disconnecting the mmu power and seeing if the problem pe...

In forum Hardware, firmware and software help

2 days ago
Try Againnutbox  nutbox-2.zip

In forum PrusaSlicer

2 days ago
I wash my build plate with Hot water and dish soap, rinse wi...

In forum How do I print this? (Printing help)

2 days ago
Is your 2.3.2, a full release, or a beta / release candidate...

In forum PrusaSlicer

2 days ago
those nut trap tops are likely to droop without supporthave ...

In forum PrusaSlicer

2 days ago
Could that have been caused by a thumb print on the corner o...

In forum How do I print this? (Printing help)

3 days ago
this is probably not the best approach to revising the value...

In forum General discussion, announcements and releases

3 days ago
the + adds a new Supa Pinda, and a revised filament sensor p...

In forum General discussion, announcements and releases

3 days ago
My 2.3.2 beta installation didn't Auto update, but My 2.3.1 ...

In forum PrusaSlicer

3 days ago
as you have changed the nozzle there is a chance that there ...

In forum How do I print this? (Printing help)

4 days ago
Good Luck!

In forum Assembly and first prints troubleshooting

5 days ago
Hi Chuck. I also had one of the perspex printers... It was 8...

In forum Assembly and first prints troubleshooting

5 days ago
The Mk3 has a 6mm aluminium main frame, and aluminium extrus...

In forum Assembly and first prints troubleshooting

6 days ago
Hi Ryan. how many teeth are there on the motor pully? I be...

In forum Assembly and first prints troubleshooting

6 days ago
Hi Ian and Stu, the Buildplate is held in place by Strong M...

In forum Hardware, firmware and software help

6 days ago
Model FULL SIZE, in Millimeters, and make sure that the line...

In forum PrusaSlicer

6 days ago
Page 1 / 343
Share: