Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
I suspect you have a small piece of filament stuck inside th...

In forum Assembly and first prints troubleshooting

2 weeks ago
maybe now is a good time for some maintenance. regards Joan

In forum Assembly and first prints troubleshooting

2 weeks ago
You seem to have supports turned on but autogenerate turned ...

In forum Assembly and first prints troubleshooting

2 weeks ago
as a temporary fix, i used 2 lengths of substantial mains fl...

In forum Assembly and first prints troubleshooting

2 weeks ago
Printers are like humans, they are all different. your tempe...

In forum General discussion, announcements and releases

3 weeks ago
Have you tried lubricating the smooth rods?regards Joan

In forum Hardware, firmware and software help

3 weeks ago
I use 0.4mm retraction. with my MMU2the MMU2 hands over cont...

In forum General discussion, announcements and releases

3 weeks ago
No Part... no .3mf file regards Joan

In forum Assembly and first prints troubleshooting

3 weeks ago
Did you set the extrusion widths to match the larger nozzle?...

In forum PrusaSlicer

3 weeks ago
does the X axis move smoothly by hand, in both directions? r...

In forum Hardware, firmware and software help

3 weeks ago
what is the weight of your failed print? is it around 1kg? r...

In forum General discussion, announcements and releases

3 weeks ago
Hi Leo, what sort of models are you looking for?Here are som...

In forum General discussion, announcements and releases

3 weeks ago
Cheers Edgar, Good luck with the new wiresregards Joan

In forum Assembly and first prints troubleshooting

3 weeks ago
Hi Edgar, the Heatbed power wires can fail intermittently op...

In forum Assembly and first prints troubleshooting

3 weeks ago
that looks as if Live Z is not set properly, the nozzle look...

In forum Hardware, firmware and software help

3 weeks ago
DONT FORGET TO RESET LIVE Z to ZERO, before doing these upgr...

In forum General discussion, announcements and releases

3 weeks ago
hmmm.... Curious!

In forum Hardware, firmware and software help

3 weeks ago
Is it the bundled filament that you are referring to? If the...

In forum General discussion, announcements and releases

3 weeks ago
My Pleasure, did it improve your first layer?Joan

In forum How do I print this? (Printing help)

3 weeks ago
Have the bearings been greased recently If not try greasing ...

In forum Hardware, firmware and software help

3 weeks ago
Page 2 / 355
Share: