Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
this looks like the nozzle is tight against the heat block a...

In forum Hardware, firmware and software help

4 weeks ago
When My X idler collapsed, I found replacement items with du...

In forum Hardware, firmware and software help

4 weeks ago
the einsy has one driver connected to two sockets for the Z ...

In forum Hardware, firmware and software help

4 weeks ago
It's a funny old world! regards Joan

In forum How do I print this? (Printing help)

4 weeks ago
before you started the print, did you use one of the barrier...

In forum How do I print this? (Printing help)

4 weeks ago
this video may help you , regards joan

In forum Comment puis-je imprimer ceci? (Aide à l'impression)

4 weeks ago
just replace the heaterI suggest you buy 2 heaters and one t...

In forum Hardware, firmware and software help

4 weeks ago
you should not need to replace the hot end!Joan

In forum Assembly and first prints troubleshooting

4 weeks ago
yes... some things are not so straight forward!Have you seen...

In forum Hardware, firmware and software help

4 weeks ago
Hi Protium, Socks are a contentious issue.. Some folk love e...

In forum Assembly and first prints troubleshooting

4 weeks ago
this link points to an article I did a number of years ago. ...

In forum How do I print this? (Printing help)

4 weeks ago
indeed... if you are doing colour change by layer height, w...

In forum PrusaSlicer

4 weeks ago
Excellent... -1.2 is not bad... If you have a powder coated...

In forum General discussion, announcements and releases

4 weeks ago
There have been different designs on prusa printers and thin...

In forum Hardware, firmware and software help

1 month ago
Hi Buzz, to me, your extruder looks to be too high on the fi...

In forum General discussion, announcements and releases

1 month ago
all G codes, have CAPITAL letters... otherwise they get igno...

In forum How do I print this? (Printing help)

1 month ago
If the problem is strings dropping onto other areas, try red...

In forum PrusaSlicer

1 month ago
I hope it works for you. Happy printing, regards Joan

In forum How do I print this? (Printing help)

1 month ago
Live Z is an art... at first it seems impossible to manage, ...

In forum General discussion, announcements and releases

1 month ago
Prusa SLicer... In the Print Settings>Advanced menu, ther...

In forum How do I print this? (Printing help)

1 month ago
Page 2 / 358
Share: