Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
Hi Craig, Try importing the STL, then right click and use th...

In forum User mods - OctoPrint, enclosures, nozzles, ...

7 hours ago
Have you tried 3DQF? Uk based, inexpensive, cardboard reels ...

In forum Hardware, firmware and software help

15 hours ago
I will have to leave this to the guys with Mini's I only ...

In forum Assembly and first prints troubleshooting

16 hours ago
Cheers Sovjet, I have a duff motor on my mmu2 at the moment,...

In forum Assembly and first prints troubleshooting

16 hours ago
when the printer is idle, does the X axis move smoothly from...

In forum Assembly and first prints troubleshooting

2 days ago
Have you removed the support plate that holds up the edges o...

In forum Hilfe zur Hardware, Firmware und Software

2 days ago
Hi Sovjet, I also prefer to print my models of this nature, ...

In forum Assembly and first prints troubleshooting

2 days ago
Live Z settings are automatically saved on the printer. Some...

In forum How do I print this? (Printing help)

2 days ago
Hi Sovjet, I would use lots of perimeters rather than 100% i...

In forum Assembly and first prints troubleshooting

2 days ago
Hi EricIf I recall correctly the section of the hot end from...

In forum Hardware, firmware and software help

2 days ago
Hi PetbelVolumetric Flow Rate is an indication of how fast y...

In forum PrusaSlicer

2 days ago
Hi Harley, it is a good idea to re test your Live Z, and adj...

In forum How do I print this? (Printing help)

2 days ago
I use a soldering iron to carve the bulk away! I have an old...

In forum Hardware, firmware and software help

4 days ago
Ah, less repairable! sorry. regards Joan

In forum Hardware, firmware and software help

5 days ago
there is a fuse in the input socket, between the IEC Plug ho...

In forum Hardware, firmware and software help

5 days ago
when you changed to the Mk3 Extruder, did you change the fir...

In forum Obecná diskuze, oznámení a novinky

5 days ago
Hi Darryll, stepper motors are able to generate electricity,...

In forum Hardware, firmware and software help

5 days ago
try disconnecting the mmu power and seeing if the problem pe...

In forum Hardware, firmware and software help

6 days ago
Try Againnutbox  nutbox-2.zip

In forum PrusaSlicer

7 days ago
I wash my build plate with Hot water and dish soap, rinse wi...

In forum How do I print this? (Printing help)

7 days ago
Page 1 / 344
Share: