Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
Hi Chris, I think I moved this thread to the correct forum. ...

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

1 day ago
Hi David. from the image, it looks like your live Z is too h...

In forum Assembly and first prints troubleshooting

2 days ago
on early layers you can usually hear the FEP Peeling off the...

In forum Hardware, firmware and software help

2 days ago
left fan comes on at 50centigrade and turns off below 50 cen...

In forum Hardware, firmware a software (Pomoc)

2 days ago
Hi Ravi, Are you at TCT on the 28th, 29,th and 30th?regards ...

In forum General discussion, announcements and releases

2 days ago
Best wishesJoan

In forum Hardware, firmware and software help

3 days ago
I think the mk8 screw thread is 6mm long, and the e3Dv6 nozz...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
the power panic board, monitors the incoming power for probl...

In forum Hardware, firmware and software help

3 days ago
did you change the nozzle? mk8 nozzles have a short thread o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
the hotend was a bit loose Here you go. I realized the heati...

In forum Assembly and first prints troubleshooting

3 days ago
it would be useful to have more info...try slicing for a 0.2...

In forum How do I print this? (Printing help)

3 days ago
possibly ThwKKing-Tex would be more descriptive or Energet...

In forum General discussion, announcements and releases

3 days ago
I believe this was discontinued by the designer, because oth...

In forum General discussion, announcements and releases

4 days ago
there are maximum parameters in firmware, which are compared...

In forum How do I print this? (Printing help)

5 days ago
can you try again with a lower value for the initial exposu...

In forum Hardware, firmware and software help

6 days ago
very likely you have a gap between the heatbreak and the noz...

In forum Hardware, firmware and software help

6 days ago
Hmmm... most of my prints are no pad, and no thump... I have...

In forum Hardware, firmware and software help

6 days ago
Page 1 / 351
Share: