JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Moderator
Hi idontwantapublicusernameI have used M302 S140 to permit ...

In forum Hardware, firmware and software help

16 hours ago
Hi alexanderswowhen I loaded your Project file, and sliced t...

In forum How do I print this? (Printing help)

17 hours ago
Hi alexanderswoyou don't give us any information about mater...

In forum How do I print this? (Printing help)

19 hours ago
Hi Bob, difficult to say without more information.... on the...

In forum How do I print this? (Printing help)

1 day ago
CA is not good at Gap filling, Epoxy may be more manageable....

In forum How do I print this? (Printing help)

2 days ago
Yeggi, finds files on many sites where as other sites only r...

In forum General discussion, announcements and releases

2 days ago
@mike-18 try Yeggi search, you might be able to find somethi...

In forum General discussion, announcements and releases

3 days ago
Scrub a dub dub, three men in a tub... I wash my textured bu...

In forum Assembly and first prints troubleshooting

3 days ago
@matt-2 Hi Matt, I believe that the Mk2, Mk2S and Mini, had ...

In forum Hardware, firmware and software help

4 days ago
does the supplier say that these STL's have been created spe...

In forum Comment puis-je imprimer ceci? (Aide à l'impression)

4 days ago
Hi Mike, Welcome. How small planes? to the best of my unders...

In forum General discussion, announcements and releases

4 days ago
Hi Master Splinter, I believe you are planning to use 5/16 s...

In forum General discussion, announcements and releases

4 days ago
Good morning. I do not have a mini. so this is guessworkbetw...

In forum Assembly and first prints troubleshooting

4 days ago
This image might help you understand the assembly informatio...

In forum Hardware, firmware and software help

4 days ago
@tim-the-novice Good morning Tim. I have built 4 Prusa Mk1, ...

In forum Assembly and first prints troubleshooting

4 days ago
Are you using 7x7 mesh bed levelling? Your live Z looks very...

In forum Dépannage pour l'assemblage et les premières impressions

4 days ago
@adda Good Morning Adda, Please be very careful with the hea...

In forum Hardware, firmware and software help

4 days ago
do you really need an extrusion multiplier of 1.15,? Joan

In forum How do I print this? (Printing help)

5 days ago
Hi Figment... I think you are out of luck, however there is ...

In forum PrusaSlicer

6 days ago
Try washing with dish soap and water. regards Joan

In forum Hardware, firmware and software help

6 days ago
Page 1 / 334
Share:

Please Login or Register